Introduction to SolidWorks: SolidWorks 1

Course information:Tuesdays and Thursdays, February 14 - April 13, 2017 (no class March 14 & 16)5:00 - 7:30 pm (8 weeks; 2 classes each week)

Edinboro University Main CampusCooper Science Hall – G07 CAD Lab

Cost: $1,295

This 40-hour class is intended to teach new users the basic tools of SolidWorks and good 3D modeling techniques. The course covers: The SolidWorks interface, basic part modeling, assemblies, drawings, and Simulation Express. This class is intended for people with no or limited SolidWorks training, however familiarity of the Windows OS is necessary. Instruction is focused on the processes of SolidWorks rather than the individual commands. At the conclusion of this course, students will have a good understanding of the SolidWorks interface and the most commonly used commands, and will posess all the required knowledge to pass the Certified SolidWorks Associate exam.

Continuing Education

Instructor: Doug Kuhn – Kuhn Tool & Die Co.

Doug Kuhn started using SolidWorks daily in 2005 and has logged over 21,000 hours designing and making drawings in SW. He is fluent in other design software and is familiar with Pro-E, Siemens NX, AutoCAD, and MasterCAM. Kuhn has taught SolidWorks classes at Precision Manufacturing Institute on an as-needed basis since 2009.

Kuhn holds SolidWorks certifications in:

CSWA – C-R7B7UPDG8D (certificate ID)

CSWP – C-TTBGU64DYUCSWP

DRAWING TOOLS – C-5FTZMK5C5WCSWP

MOLD TOOLS – C-SJVL6KKU2UCSWP

SHEET METAL – C-ZCPZDCKPJA

CSWP SURFACING – C-JBLHDR5CV4

CSWP WELDMENTS – C-P4257C3KM4

CSWE – C-54VAF27B98

888-8GO-BORO | www.edinboro.edu/continuing-education

Space is limited. To reserve your spot, visitwww.edinboro.edu/continuing-ed-reg or contact Beth Zewe at zewe@edinboro.edu or 814-732-1420.