• Biometric Attendance is mandatory for all candidates
• 80% Attendance is required to be eligible for examination and Certification
• Both IN and OUT Attendance is required to be marked
• Candidates who fail to mark both IN and OUT attendances in the daywill be treated as absent
• In case Biometric System is not functional during the day then concernedauthorities are to be notified by email and manual attendance record has tobe provided as directed by the concerned authority.
• After started a new batch or batch end date revised then SDC need to do Master Sync and Download Learner Data for concern batch.
• Important Note:
SDC are requested to utmost care while enrolling the finger prints in
biometric device, later if found any mismatch then SDC will be solely
responsible.
Important Instructions
Supported Hardware:
• enBioScan-C1 (HFDU08) from BioEnable
• MFS100 from Mantra Softech
Minimum Requirements:
• Windows 7 or higher
• MS-Office 2010 or higher
• Microsoft .NET Framework 3.5 or higher
• Broadband Internet
Attendance Software - BizClient
• In SDC login Go to Content Management > Content Downloads
• Download Attendance System – Bizclient Setup (New)
Download Attendance Software - BizClient
12
• Specify destination where Software will be installed.
• In case of WINDOWS 10 , installation SHOULD NOT be done in C: drive, youmay install it in D: or E: drive
Installation
• After installation Shortcut “BizClient for Domain Skilling” is available on Desktop
• RightClick on the Shortcut
• Click on Properties
Administrator setting
• Sync with Server will start.
• First sync may take some time.
After successful synchronization
Close the tab
Synchronization
Download Learner Data
• Select the pencil icon to Select the Course and Batch
Click on
Download to download
Learner & Trainer details
Data Download
1
3
2
Download Learners Data
1. Select Download Data2. Select Learners radio button
3. Click on “Click here to Download Data”
123456
Learners Fingerprint Enrollment
1. Enable Learners radio button2. Select LearnerImportant Note : Capture and save one by one all 10 fingers of each candidate.
3. Select Finger4. Click on “Capture …. Finger”
1
2
3
4
123456
Employee Fingerprint Enrollment1
2
3
4
1. Enable Employees radio button2. Select TrainerImportant Note : Capture and save one by one all 10 fingers of each trainer.
3. Select Finger4. Click on “Capture …. Finger”
Attendance report on portal
• 1. In SDC login Go to Attendance Management
• 2. Select Attendance-Report
• 3. Click on Attendance tab of respective batch to check attendance report
1
2
3
Learner In-Out Attendance Records
Important Note:
If the learner in & out time difference is equal or more than shift duration then only such learners
attendance considered as Present.
Recommended