Embed Size (px)
Citation preview
Control Yoke Reconnection
of
EMBRAER 170
Eng.Ramez Enwesri (B1)
Libya – Petro Air Co.
The Task
Task 27-11-12-840-801-A gives all steps and procedure to carry out the Control Yoke Disconnect Device – Reconnection.
In this presentation we will focus on some points which might be help, where we carried out this task few days ago.
But you have to obey the task.
Eng.Ramez Enwesri (B1) - Libya
The Practices Note
You do not need to remove any parts to reach the Disconnect Device. The Area is clear to set the tools.
It will be good to use a Multimeter with long terminal leads, to be far enough to hear the sound, as result of Close Circuit between pins A & B.
You have to know that the Reconnect Wrench jaws movement should be out of each other.
When you hear the sound of the Multimeter, do not stop. Wait for seconds, and turn the Reconnect Wrench for more 2 or 3 turns. You will feel a strong reaction, then stop.
Eng.Ramez Enwesri (B1) - Libya
Jaws movement
Floating Plate Movement Eng.Ramez Enwesri (B1) - Libya
Ramez Ramadan Enwesri
Eng. B1
Libya – Petro Air Co.
Email: [email protected]
Mobile: +218 91 324 6152
