8/12/2019 Is b 2001004
1/6
Bulletin No. : ISB-2001004
Date : July 25,2001
Component
catagory: 09 - Body and accessories
Bulletin Group : Technical
Distribution : World wide
Sub ect : Memor in ut to REKESModels : Musso and Korando with the REKES
Condition :
This service bulletin is issused to clarify the procedure of REKES memory input on workshop manual.
REKES memory is inputed when,
The REKES transmitter is lost or faulty The REKES receiver is faultyWork rocedure :
1. 1st method : input memory using the switch of the REKES receiver
1-1. Location of the REKES receiver
1-1-1. Musso (before 1998 ; V.I.N. ~ 140079)
: under the dashboard and heater unit (rear side of audio head unit)
This service bulletin is intended for internal use only. All information, illustrations and specifications contained in this bulletin are
based on the latest product information available at the time of issue.
International A/S & parts team
REKES receiveron the bracket: Musso (before 1998)
REKES receiver: Musso (after 1998)and Korando
Tel: 82-31-610-1400
Fax: 82-31-610-3373
E-mail:[email protected]
Printed in Korea
SSANGYONG MOTORS COMPANYISB-2001004
Page No: 1 of 6
8/12/2019 Is b 2001004
2/6
1-1-2. Musso (after 1998 ; V.I.N. 140080~)
: under the dashboard and upper the acceleration pedal with STICS unit
1-1-3. Korando : under the dashboard and upper the acceleration pedal
This service bulletin is intended for internal use only. All information, illustrations and specifications contained in this bulletin are
based on the latest product information available at the time of issue.
International A/S & parts team
Air duct
Vacuum linesof the ignition
key switch(diesel only)
STICS unit
Crank assy-bell,
Acceleration
REKES
receiver
REKESreceiver
Crank assy
-bell,Acceleration
Accelerationcable
Heaterunit
Air duct
Tel: 82-31-610-1400
Fax: 82-31-610-3373
E-mail:[email protected]
Printed in Korea
SSANGYONG MOTORS COMPANYISB-2001004
Page No: 2 of 6
8/12/2019 Is b 2001004
3/6
1-2. Location of the input memory switch (Musso and Korando all)
1-3. Formation of the input memory switch (Musso and Korando all)
1-3-1. Oldversion receiver (~ Apr.19,1997)
1-3-2. Newversion receiver (Apr.20,1997 ~)
This service bulletin is intended for internal use only. All information, illustrations and specifications contained in this bulletin are
based on the latest product information available at the time of issue.
International A/S & parts team
REKES receiver
Input memory switch
1 2
1st transmitterinput
position
Operatingposition
2nd transmitterinput
position
Transmitter(only one)
inputposition
Operatingposition
Tel: 82-31-610-1400
Fax: 82-31-610-3373
E-mail:[email protected]
Printed in Korea
SSANGYONG MOTORS COMPANYISB-2001004
Page No: 3 of 6
8/12/2019 Is b 2001004
4/6
1-4. Input memory procedure : in condition of taking the key out
1-4-1. Oldversion receiver (~ Apr.19,1997)
Replace the REKES receiver with a new one and connect the wiring connector when
the REKES receiver is faulty only.
Set the input memory switch of the REKES receiver onto the no.1 or no.2 position and
push the lock or unlock button on the REKES transmitter.
Set the input memory switch of the REKES receiver onto the central position and
close all doors.
Check the operation of central door lock system by pushing the lock and unlock button
on the REKES transmitter.
This REKES version can use two transmitters simultaneously for a vehicle.
1-4-2. Newversion receiver (Apr.20,1997 ~)
Replace the REKES receiver with a new one and connect the wiring connector when
the REKES receiver is faulty only. Set the input memory switch of the REKES receiver onto the position and
push the lock or unlock button on the REKES transmitter.
Set the input memory switch of the REKES receiver onto the position and
close all doors.
Check the operation of door locking system by pushing the lock and unlock button
on the REKES transmitter.
This REKES version can use only one transmitter for a vehicle.
2. 2nd method : diagnosis socket use
2-1. Location and terminal arrangement of the diagnosis socket
2-1-1. Vehicle was made before 1998 : engine room left inside (near the fuse box)
[Terminal arrangement]
1. Ground 8. Blank
2. Ignition switch ON 9. Full time T/C
3. Power supply B+ (12V) 10. Blank
4. REKES input memory 11. Cruse control
5. Engine RPM(Gasoline) 12. Blank
6. Part time T/C 13. ABS7. STICS 14. Engine ECU
This service bulletin is intended for internal use only. All information, illustrations and specifications contained in this bulletin are
based on the latest product information available at the time of issue.
International A/S & parts team
3 2
567 4
1
91011
121314
8
Tel: 82-31-610-1400
Fax: 82-31-610-3373
E-mail:[email protected]
Printed in Korea
SSANGYONG MOTORS COMPANYISB-2001004
Page No: 4 of 6
8/12/2019 Is b 2001004
5/6
2-1-2. Vehicle was made after 1998 : engine room left inside (near the fuse box)
[Terminal arrangement]
1. Ground 11. Blank
2. Ignition switch ON 12. Blank
3. Power supply B+ (12V) 13. ABS
4. REKES input memory 14. Engine ECU
5. Engine RPM (Gasoline) 15. Full time T/C
6. Part time T/C 16. Immobilizer
7. STICS 17. Blank
8. Blank 18. Auto T/M (BTRA-TCU)
9. Blank 19. Blank
10. Air bag 20. ECS
2-1-3. Musso 2001 model year (V.I.N. 247012~) : under the dashboard (driver side)
5. Ground
6. STICS
7. Immobilizer
8. ABS
9. Air bag
10. Blank
[Terminal arrangement] 11. Blank
12. Full time T/C
1. ECS 13. Full & Part time T/C ,TOD
2. Ignition switch ON 14. Auto T/M (BTRA-TCU)
3. REKES input memory 15. Blank4. Ground 16. Power supply B+ (12V)
2-2. Input memory procedure : in condition of taking the key out
2-2-1. Oldversion receiver (~ Apr.19,1997)
Replace the REKES receiver with a new one and connect the wiring connector when
the REKES receiver is faulty only.
DC 5V currentsupply between terminal no.1(ground) and no.4(REKES input memory)
on the diagnosis socket in engine room. Push the lock or unlock button on the REKES transmitter.
Input memory and close all doors.
Check the operation of door locking system by pushing the lock and unlock button
on the REKES transmitter.
This service bulletin is intended for internal use only. All information, illustrations and specifications contained in this bulletin are
based on the latest product information available at the time of issue.
International A/S & parts team
1 2
13 14 15 16 17 18 19 20
5 6 7 8 9 10 11 12
3 4
8 7 6 5 4 3 2 1
16 15 14 13 12 11 10 9
Tel: 82-31-610-1400
Fax: 82-31-610-3373
E-mail:[email protected]
Printed in Korea
SSANGYONG MOTORS COMPANYISB-2001004
Page No: 5 of 6
8/12/2019 Is b 2001004
6/6
2-2-2. Newversion receiver (Apr.20,1997 ~)
Replace the REKES receiver with a new one and connect the wiring connector when
the REKES receiver is faulty only.
Except the Musso 2001 model year
Connect the terminal no.3(power supply B+,12V) and terminal no.4(REKES input memory)
which are on the diagnosis socket in engine room with service lead wire.
Musso 2001 model year only
Connect the terminal no.3(REKES input memory) and terminal no.16(power supply B+,12V)
which are on the diagnosis socket in engine room with service lead wire.
Push the lock or unlock button on the REKES transmitter.
Input memory and close all doors.
Check the operation of door locking system by pushing the lock and unlock button
on the REKES transmitter.
3. Part no. index
3-1. Transmitter assy-REKES
8715005001X : Ssangyong logo (Jul.01,1993 ~ Jun.30,1994)
8715005000 : Ssangyong logo (Jul.01,1994 ~ Mar.29,1999)
8715005001 : Daewoo logo (Mar.30,1999 ~)
8715005010: Ssangyong logo (Mar.30,1999 ~)
8715005800 : Daewoo logo, with EU regulation (Nov.30,1998 ~ Mar.29,1999)
8715005810: Ssangyong logo, with EU regulation (Mar.30,1999 ~)
3-2. Receiver-REKES
8716105001X (Jul.01,1993 ~ Jun.30,1994)
8716105000(Jul.01,1994 ~ )
8716105800Z : with EU regulation (Nov.30,1998 ~ Mar.29,1999)
8716105800: with EU regulation (Mar.30,1999 ~)
This service bulletin is intended for internal use only. All information, illustrations and specifications contained in this bulletin are
based on the latest product information available at the time of issue.
International A/S & parts team
Tel: 82-31-610-1400
Fax: 82-31-610-3373
E-mail:[email protected]
Printed in Korea
SSANGYONG MOTORS COMPANYISB-2001004
Page No: 6 of 6