SheepShaver ReadMe FirstThese builds were compiled from the source as it existed in CVS on July 21st 2008Improvements since the July 12th build:- Mouse buttons now correctly numbered.- If no ROM can be opened SheepShaver will quietly quit instead of hang.- Refresh Rate "Dynamic" now sets correctly frameskip to "0" and is now the preferred setting for the software cursor version of SheepShaver.Build instructions were used as provided by Kelvin here:http://www.nomicro.com/SheepShaver.htmlThe PPC and Intel builds were merged into Universal Binaries using the lipo command as described here:http://developer.apple.com/technotes/tn2005/tn2137.htmlThese builds should work in MacOSX 10.4 (Tiger) and 10.5 (Leopard) on PPC and Intel Macs. Tested in Leopard on Intel Core 2 Duo iMac and in Tiger on PowerBook G4.If you set up SheepShaver for the first time, you will need a compatible ROM file besides the files in this SheepShaver folder, and you will need a MacOS install CD (or a install CD disk image).If you have a existing SheepShaver setup, you can replace the application with the new application.See the included manual for more information.Questions and comments please on Emaculation SheepShaver forum:http://www.emaculation.com/forum/Disclaimer:I am no software developer, just a hobbyist as you probably are. I can give no guarantee that this software will work or that this software will not damage your files or your system. If you use this software, all possible consequences are your own responsibility.July 12, 2008Ronald P. RegensburgAmsterdam, Netherlands