8/12/2019 Is b 2001013

1/2

ISB-2001013

OCT. 12. 2001

Component category : 04-BRAKES

TECHNICAL

WORLD WIDE

SUBJECT : INFORMATION OF NEW ABS/ABD UNIT

MODELS : KORANDO with ABS/ABD

CONDITION:

The ABS/ABD MODULATOR has changed for the higher quality competition.

Applied Vehicle No.(VIN No) :

- KORANDO : 125702 ~ (MAY. 28, 2001)

Changed items :

- The EBCM and modulator are unified

Part number change

1) WET : The modulator is filled with the brake fluid.2) DRY : The modulator is not filled with the brake fluid.

The ABS & ABS/ABD of MUSSO is not changed.

Position of the ECU(EBCM) - only ABS/ABD applied vehicle

under the co-driver's seat right side of engine room right side of engine room

(beside the coolant tank) (beside the coolant tank)

This service bulletin is intended for internal use only. All information, illustrations and specifications contained in this bulletin are

based on the latest product information available at the time of issue.

Bulletin No. :

Date :

Bulletin Group :

Distribution :

VERSION NO. ABS 5.3 ABS/ABD 5.3 ABS 5.3(II) ABS/ABD 5.3(II)

48910-08000(DRY) 48940-08000(DRY)

48910-08A00(WET) 48940-08A00(WET)

ECU(EBCM) - 86710-05800 - -

MODULATOR/EBCM unified separated unified unified

MODULATOR

BEFORE AFTER

48910-06300 48940-06300

International A/S Parts Team

Tel: 82-31-610-1400

Fax: 82-31-610-3733

E-mail:sykim1@smotor.com

Printed in Korea

SSANGYONG MOTORS COMPANY

ISB-2001013

Page No: 1 of 2

8/12/2019 Is b 2001013

2/2

Cautions- In case of the only ABS, the old and new parts are mutually interchangeable.

- In case of the ABS/ABD, the old and new parts are notmutually interchangeable. Do not use together.

- If your scan tool is not updated with EURO III package, you can't diagnose the ABS 5.3(II) and

ABS/ABD 5.3(II). So in case of non update, to purchase the new program is necessary.

New software program information- Part No. : SC11017-A5-2

- Part Name : KORANDO ABS, ABS/ABD BRAKE UP-DATE PROGRAM

- Purchase Channel : Same as it of parts.

Addition - Air bleeding the BRAKE

- Wet type modulator : Normal bleeding will be needed.

- Dry type modulator : Use the brake bleeding program in the scan tool to bleed the modulator.

Manual bleeding of the modulator is notpossible.

This service bulletin is intended for internal use only. All information, illustrations and specifications contained in this bulletin are

based on the latest product information available at the time of issue.

International A/S Parts Team

Tel: 82-31-610-1400

Fax: 82-31-610-3733

E-mail:sykim1@smotor.com

Printed in Korea

SSANGYONG MOTORS COMPANY

ISB-2001013

Page No: 2 of 2