Fixturlaser Dials Kit Setup Instructions

Fixturlaser Dials

Mount the first V-bracket to one shaft, and hand-tighten the nut. Then use the tightening tool to turn the nut one full rotation.

Mount the second V-bracket to the opposite shaft. Hand-tighten the nut. For now, leave this fixture loose enough to adjust.

S T E P 1

S T E P 2

Fixturlaser Dials

Measure the distance between the two V-brackets, center to center.

Select the appropriate rod length. From the rod holder, the rod should extend 25 mm shorter than the distance you measured between the two V-brackets. Use the tightning tool to secure.

S T E P 3

S T E P 4

Fixturlaser Dials

Set the second rod to the same length in the second rod holder.

Offset the two V-brackets. Attach both rod holders at the same height to the posts. Hand-tighten the nuts.

S T E P 5

S T E P 6

Fixturlaser Dials

Reversible Clamp – slide off to reverse. The hole into which the dial stem is inserted should be clos-est to rod’s end.

Rotate the loose V-bracket into position, so that the dial clamp hole is directly over the top of the landing pad. Hand-tighten the loose V-bracket, then use the tightening tool to turn the nut one full rotation. Make sure both V-brackets are securely fixed to the shafts.

R E V E R S I B L E C L A M P

S T E P 7

Note: Fixturlaser Dials Kit indicators (either imperial & metric) have metric diameter stems.

Fits the Fixturlaser Dials Kit indicator with 8 mm stem

Fits dial indicator with 3/8” stems

Note: Make sure the dial clamps do not touch the opposing rod.

Fixturlaser Dials

Attach the first dial and hand-tighten the nut. Adjust the rod holder up or down until the dial is set to half-travel.

Attach the second dial. Hand-tighten the nut.

S T E P 8

S T E P 9

Welcome to our world Since the very beginning in 1984, ACOEM AB, (formerly known as ELOS Fixturlaser AB) has helped industries throughout the world to achieve more profitable and sustainable production. We have reached where we are today by having the courage to think beyond the norm and follow slightly unconventional paths. We have had the courage to make mistakes and find new directions. Through our resolve, ambition and knowledge we have become a global player and a leader in innovative, user-friendly shaft alignment.

View our following resources for more information

www.youtube.com/user/FIXTURLASER

www.alignmentknowledge.com

The Fixturlaser Dials Kit was designed to be used with the free Fixturlaser Dials App.

www.alignmentknowledge.comACOEM AB

Östergårdsgatan 9SE-431 53 Mölndal

SWEDEN Phone +4631 706 28 00

Fax +4631 706 28 50