1
IMPORTANT NOTE! Non-observance may lead to the loss of the entire wheel! Ensure that all work in and on the wheel bearing unit (brake system, tie rod, wheel) is carried out in compliance with the vehicle manufacturer’s instructions! WHEEL BEARING REPAIR SOLUTION FOR TRANSPORTERS USING THE SPECIAL TOOL 1002215 TECHNICAL INFO NO. 2007 For the first time, it is now possible to replace the wheel bearing of the front axle of the vehicles listed above without having to replace the entire steering swivel assembly. In contrast to the repair methods suggested by the manufacturer, RUVILLE now offers an inex- pensive repair option. The otherwise mandatory wheel alignment is no longer necessary and the associated downtimes of the vehicle in the work- shop are reduced. A special tool is required for the repair work to en- sure that the wheel bearing is pressed in over the outer ring and the locking ring clicks into place in the groove in the steering swivel. There are more detailed repair instructions on dismantling and assembly in the brochure “Wheel bearing repair solution for transporters” and on the DVD in the tool case (1002215). EGON VON RUVILLE GmbH Billbrookdeich 112 22113 Hamburg Germany Tel.: +49 (0)40 73344 - 0 Fax: +49 (0)40 73344 - 199 [email protected] www.ruville.de Image 1: The wheel bearing unit can now be replaced individually Image 3: The locking ring must lie flush with the steering swivel Image 2: 1002215 – The special tool is imperative for the repair work VEHICLE MANUFACTURER / MODELS: Mercedes-Benz Sprinter (906), Vito (W639), Viano (W639) Volkswagen Crafter (2E) AXLE: Front axle at rear wheel drive vehicles Wheel-Bearing-No. Tool-No.: 5150 1002215 5151 5154 APPLIES TO PART NO.: 2007/0.1/01.2012/PDF-GB Subject to change. Copyright © 2012 EGON VON RUVILLE GmbH MOTOR | CHASSIS | SERVICE EXCELLENCE IN PC PARTS INFORMATION Corresponding spare parts can be found in our online catalogue at www.ruville.de. Where reference is made to the spare parts numbers of the vehicle manufacturers, this is only for the purposes of comparison.

Wheel bearing repair solution for transporters - REPXPERT · mercedes-Benz Sprinter (906), Vito (W639), Viano (W639) Volkswagen Crafter (2E) axle: Front axle at rear wheel drive vehicles

Embed Size (px)

Citation preview

Page 1: Wheel bearing repair solution for transporters - REPXPERT · mercedes-Benz Sprinter (906), Vito (W639), Viano (W639) Volkswagen Crafter (2E) axle: Front axle at rear wheel drive vehicles

Important note! Non-observance may lead to the loss of the entire wheel!

Ensure that all work in and on the wheel bearing unit (brake system, tie rod, wheel) is carried out in compliance with the vehicle manufacturer’s instructions!

Wheel bearing repair solution for transporters using the special tool 1002215technIcal Info no. 2007

For the first time, it is now possible to replace the wheel bearing of the front axle of the vehicles listed above without having to replace the entire steering swivel assembly.

In contrast to the repair methods suggested by the manufacturer, RUVILLE now offers an inex-pensive repair option. The otherwise mandatory wheel alignment is no longer necessary and the associated downtimes of the vehicle in the work-shop are reduced.

A special tool is required for the repair work to en-sure that the wheel bearing is pressed in over the outer ring and the locking ring clicks into place in the groove in the steering swivel.

There are more detailed repair instructions on dismantling and assembly in the brochure “Wheel bearing repair solution for transporters” and on the DVD in the tool case (1002215).

egon von ruville gmbh • billbrookdeich 112 • 22113 hamburg • germany • tel.: +49 (0)40 73344 - 0 • fax: +49 (0)40 73344 - 199 • [email protected] • www.ruville.de

Image 1: The wheel bearing unit can now be replaced individually

Image 3: The locking ring must lie flush with the steering swivel

Image 2: 1002215 – The special tool is imperative for the repair work

VehIcle manufacturer / modelS:mercedes-Benz Sprinter (906), Vito (W639), Viano (W639)Volkswagen Crafter (2E)

axle:

Front axle at rear wheel drive vehicles

Wheel-Bearing-no. tool-no.:

5150 100221551515154

applIeS to part no.:

2007

/0.1

/01.

2012

/PD

F-G

B

S

ubje

ct to

cha

nge.

Cop

yrig

ht ©

201

2 E

GO

N V

ON

RU

VIL

LE G

mbHmotor | chaSSIS | SerVIce excellence In pc partS

InformatIonCorresponding spare parts can be found in our online catalogue at www.ruville.de. Where reference is made to the spare parts numbers of the vehicle manufacturers, this is only for the purposes of comparison.