7/26/2019 TP177 Programing

1/13

Program uploading for Touch screen TP177B color (Ethernet mode)

For change this program is needed:

1-Ethernet cross wire.

2-Siemens WinCC Flexible 2007 or WinCC Flexible 2005 SP1 HF7 software

3-Computer with Ethernet port.

Procedure

1-Connect the Ethernet cross wire between the touch screen and computer.

Ethernetport

7/26/2019 TP177 Programing

2/13

2-Disconnect the power supply of touch screen, wait 5 seconds and reconnect, after 20 seconds touch screen shows the

follow menu.(This menu runs only 3 or 4 Seconds), press Control panel.

PressControl

panel

7/26/2019 TP177 Programing

3/13

3- Double click in transfer.

Doubleclick

inTransfer

7/26/2019 TP177 Programing

4/13

4-The next screen appears, tilt and set the options like the next example. And press the button advance.

PressAdvanced

Setthisoptions

7/26/2019 TP177 Programing

5/13

5-In the next screen press onboard LAN Ethernet Driver after this press properties

Setthisoption

PressProperties

7/26/2019 TP177 Programing

6/13

6-In the next screen tilt Specify an IP address and set IP address 192.168.56.198 And set Subnet Mask 255.255.255.0.

7/26/2019 TP177 Programing

7/13

7-Press OK in all the screens until the next screen (see picture), and double click in OP.

Doubleclick

inOP

7/26/2019 TP177 Programing

8/13

8-Press the button Device.

PressDevice

7/26/2019 TP177 Programing

9/13

9-Press the button Reboot and yes

Press

Reboot

7/26/2019 TP177 Programing

10/13

10-The touch screen start to reboot, after 20 second appear the Loader menu. Press Transfer in the screen appear the

message connecting to host.

The touch screen settings are finished.

PressTransfer

7/26/2019 TP177 Programing

11/13

11-Computer Settings.

You must to set in the Lan -internet properties The IP address 192.168.56.196 And the Subnet mask 255.255.255.0

(Note that the IP address in the touch screen is not the same than the IP address in the computer).

Disconnect and reconnect the Ethernet wire and wait that the computer Recognize the connection. And

ready, the touch screen is connected.

7/26/2019 TP177 Programing

12/13

12-Start the WinCC Flexible Program clicking in the .hmitouchscreen program file, and set in transfer the Ethernetmode and the IP address 192.168.56.198 ( the same IP address than the touchscreen).

7/26/2019 TP177 Programing

13/13

13- Set the parameters of the transfer. And click in transfer in order to start the transferring.