Embed Size (px)
Citation preview
TMDE PROGRAM
TMDE PROGRAMNSWC Det Seal Beach
Steve Cluer562-626-7578
ACTION ITEM UPDATE & STATUS
TMDE PROGRAM
Action Item Update Summary
• DMM & Probe Alignment
• Antenna Analyzer (S115BQ)
• EMI Test Equipment Requirements
TMDE PROGRAM
• Option 1– Stand Alone DMMs
• SCATS 4237, 4249, 4212 (Partial), & 4195 (Partial)
– Stand Alone Voltage Probes (Only)• SCAT 4242
– Stand Alone Current Probes (Only)• SCAT 4236
DMM & V/I Probes Alignment
TMDE PROGRAM
• Separate DMM & Probes– Stand Alone Probes Useable With Any Typical DMM
(Handheld or Benchtop)
– Probes SCAT 4242 & 4236 Typically Called Out Separately
– DMM Typically Called Out as Standalone without Probes
– High Probe Population in Inventory is Standalone
– Permits DMM SCAT Code Combination Under Single Standard Model (NAVSEA Spec in process at NRL)
DMM & V/I Probes Alignment
TMDE PROGRAM
• Option 2 (Combine Meters & Probes)– Combine DMM with Voltage Probes
• SCATS 4237, 4242
– Combine DMM with Current Probes• SCAT 4236 & 4249
DMM & V/I Probes Alignment
TMDE PROGRAM
• Combined Meters & Probes – Increased Cost
• (Unit Price Increased due to Divided Buy Population
• Multiple Model Life Cycle Support Required
– Replacement of either DMM or Probe will Require Purchase of both
– MRC Decks will Require Updates
– Requires Replacement of High Percentage of Current Inventory to Achieve Configuration Control
DMM & V/I Probes Alignment
TMDE PROGRAM
• Option 3 (Standalone Clamp I Meter)– Combine DMM with Voltage Probes
• SCATS 4237, 4242
– Standalone Clamp on V/I DMM • SCAT 4236
– Standalone DMM• SCAT 4249
DMM & V/I Probes Alignment
TMDE PROGRAM
• Standalone I Meter – Increased Cost
• (Unit Price Increased due to Divided Buy Population
• Multiple Model Life Cycle Support Required
– Replacement of either DMM or Probe will Require Purchase of both (Voltage Only)
– MRC Decks will Require Updates (Voltage Only)
– Requires Replacement of High Percentage of Current Inventory to Achieve Configuration Control
DMM & V/I Probes Alignment
TMDE PROGRAM
• Field Evaluation Complete (USS John Young)• Draft Evaluation Report (Mark McHugh)• Report Review by CWP & TMDE Program• CWP Project Conclusion & Implementation• Options Under Consideration:
– Separate Analyzer from Adapters (Cost Savings)
– Spectrum Analyzer and Power Measurement Option (support for EMI community)
Antenna Analyzer (S115BQ)
TMDE PROGRAM
• EMI Measurements Requirements Review for O & I Level (NAVSEA 053)
• O Level Requirements Issues:– Combine Antenna Analyzer & Spectrum Analyzer
– Delete Filter Requirements
– Combine Radiation Hazard Meter with Spectrum Analyzer
• I Level Requirements Issues:– Standalone Antenna Analyzer
– Standalone Broadband Spectrum Analyzer Required
– Filters Required
• Project Conclusion & Implementation (NAVSEA 053)
EMI GPETE Requirements
