Upload
william-kibbe
View
217
Download
0
Embed Size (px)
Citation preview
8/18/2019 Relay Test JS 091907
1/3
RELAY TEST JOBSHEET
Name ________________________ Station _________________ Date ______________
Objective
Upon completion of this job sheet you will have demonstrated the ability to test a
standard automotive relay. You must know how to perform this task to pass the ASE
Electrical Test.
Tools and Materials
Vehicle DVOM
Alldata Jumper Wires
Power Probe
Protective Clothing
Safety Glasses
Describe the vehicle being worked on:
Year ________ Make __________________________ Model _____________________
VIN ________________________________ Engine type and size __________________
PROCEDURE
1. Pull the vehicle into the shop and locate a standard underhood relay.
2. Remove the relay and identify the standard terminals as shown on the next page.
3. With the relay de-energeized, measure the resistance between terminals 30 & 87a.
It has _______________________ohms of resistance.
4. What should the resistance be? ___________________ohms
5. With the relay de-energeized, measure the resistance between terminals 30 & 87._______________________ohms
6. What should the resistance be? ___________________ohms
7. With a power probe or jumper wires, apply 12V to terminal 86 and ground to
terminal 85. You should hear the relay “click”. Do you? ________________
8/18/2019 Relay Test JS 091907
2/3
8. With power and ground applied to the relay (energized) measure the resistance
between terminals 30 & 87a. It has ____________________ohms of resistance.
9. What should the resistance be? ___________________ohms
10. With power and ground applied to the relay (energized) measure the resistance
between terminals 30 & 87. It has ____________________ohms of resistance.
11. What should the resistance be? ___________________ohms
Based on the tests above is the relay good or bad? _____________________
Problems Encountered
8/18/2019 Relay Test JS 091907
3/3
Instructor’s Comments