38
McKenzie Method Dr. D. N. Bid

McKenzie Method Physiopedia

Embed Size (px)

DESCRIPTION

McKenzie techniques for back pain

Citation preview

Page 1: McKenzie Method Physiopedia

McKenzie Method

Dr. D. N. Bid

Page 2: McKenzie Method Physiopedia

Description/definition

• The McKenzie method is a classification system and a classification-based treatment for patients with low back pain. A synonym for the McKenzie method is mechanical diagnosis and therapy (MTD). The McKenzie method was developed in 1981 by Robin McKenzie, a physical therapist from New Zealand.[1][2]

Page 3: McKenzie Method Physiopedia

• The McKenzie method exists of 3 steps: evaluation, treatment and prevention. The evaluation is received using repeated movements and sustained positions. With the aim to elicit a pattern of pain responses, called centralization, the symptoms of the lower limbs and lower back are classified into 3 subgroups: derangement syndrome, dysfunction syndrome and postural syndrome. The choice of exercises in the McKenzie method is based upon the direction (flexion, extension or lateral shift of the spine). The aims of the therapy are: reducing pain, centralization of symptoms (symptoms migrating into the middle line of the body) and the complete recovery of pain. The prevention step consists of educating and encouraging the patient to exercise regularly and self-care.

Page 4: McKenzie Method Physiopedia

• All exercises for the lumbar spine are repeated a number of times to end-range on spinal symptoms in one direction. When you do only 1 repetition, this will cause pain. When you repeat it several times the pain will decrease. Also after movement termination the changes in pain intensity can persist, which leads to a treatment modality. A single direction of repeated movements or sustained postures leads to sequential and lasting abolition of all distal referred symptoms and subsequent abolition of any remaining spinal pain.

Page 5: McKenzie Method Physiopedia

Classification

• McKenzie described in 1981 for the first time the mechanical classification in the McKenzie system. The patients are classified into four groups according to the mechanical and symptomatic response to repeated movements and sustained positions. Each syndrome demands a different management approach. In the paragraph below you will find the four categories of the McKenzie classification with their descriptions.

Page 6: McKenzie Method Physiopedia

1. Posture syndrome• Refers to pain which occurs due to a mechanical deformation of normal

soft tissue from prolonged end range loading of periarticular structures. • The pain arises during static positioning of the spine: for example

sustained slouched sitting. • The pain disappears when the patient is moved out of the static position. • The treatment includes: • Patient education • Correction of the posture = improving posture by restoring lumbar

lordosis • Avoiding provocative postures = avoid prolonged tensile stress on normal

structure

Page 7: McKenzie Method Physiopedia

2. Dysfunction syndrome• Refers to pain which is a result of mechanical deformation

of structurally impaired tissues like scar tissue or adhered or adaptively shortened tissue.

• The pain arises at the end range of a restricted movement. • The treatment includes: • Mobilizing exercises in the direction of the dysfunction or in

the direction that reproduces the pain.The aim is to remodel that tissue, which limits the movement, through exercises so that it becomes pain-free over time.

Page 8: McKenzie Method Physiopedia

• 3. Derangement syndrome [4][5][6][7][8][9] • Is the most prevalent treatment classification. • Refers to pain which is caused by a disturbance in the normal resting position of the

affected joint surfaces.

• This syndrome is classified in two groups: • (1) Irreducible derangement • The criteria for derangement are present. • No strategy is capable to produce a permanent change in symptoms. • (2) Reducible derangement • Shows one direction of repeated movement which decreases or centralizes referred

symptoms = preferred direction. • Shows also an opposite repeated movement characterized by production or increase

or distal movement of the symptoms.

• The treatment includes: • Examination of the patient’s symptomatic and mechanical response to repeated

movements or sustained positions because the chosen treatment depends on the clinically induced directional preference.

Page 9: McKenzie Method Physiopedia

• 4. Other or non-mechanical syndrome [4][5][6][7][9] • Contains minority of patients who do not fit within one of the

three mechanical syndromes but who demonstrate symptoms and signs of other pathology like:

o Spinal stenosiso Hip disorderso Sacroiliac disorderso Low back pain in pregnancyo Zygapophyseal disorderso Spondylolysis and spondylolisthesiso Post-surgical problems

• This classification shows strong inter-rater reliability amongst physiotherapist trained in the McKenzie method.

Page 10: McKenzie Method Physiopedia
Page 11: McKenzie Method Physiopedia
Page 12: McKenzie Method Physiopedia
Page 13: McKenzie Method Physiopedia
Page 14: McKenzie Method Physiopedia
Page 15: McKenzie Method Physiopedia
Page 16: McKenzie Method Physiopedia
Page 17: McKenzie Method Physiopedia
Page 18: McKenzie Method Physiopedia
Page 19: McKenzie Method Physiopedia
Page 20: McKenzie Method Physiopedia
Page 21: McKenzie Method Physiopedia
Page 22: McKenzie Method Physiopedia
Page 23: McKenzie Method Physiopedia
Page 24: McKenzie Method Physiopedia
Page 25: McKenzie Method Physiopedia
Page 26: McKenzie Method Physiopedia
Page 27: McKenzie Method Physiopedia
Page 28: McKenzie Method Physiopedia
Page 29: McKenzie Method Physiopedia
Page 30: McKenzie Method Physiopedia
Page 31: McKenzie Method Physiopedia
Page 32: McKenzie Method Physiopedia
Page 33: McKenzie Method Physiopedia
Page 34: McKenzie Method Physiopedia
Page 35: McKenzie Method Physiopedia
Page 36: McKenzie Method Physiopedia
Page 37: McKenzie Method Physiopedia
Page 38: McKenzie Method Physiopedia