Upload
randolph-fox
View
223
Download
0
Embed Size (px)
Citation preview
What is MUTCD?
• “the national standard for all traffic control devices”
• Defines TCDs in detail:– Fonts and appearance– Positioning– Usage
• Originates from 1927 document for rural roads
• Current version is 2003 ed., rev. 1
Availability
• Available online at http://mutcd.fhwa.dot.gov.
Requirement to Follow
• Per 1966 Highway Safety Act, all public roadways must be in “substantial conformance”.
• No compliance = no federal funds.• Four levels of compliance:
– Standard: must follow– Guidance: recommended– Option: “statement of practice,” may be used to
modify standard of guidance– Support: informational, not required
State MUTCD?
• States may have their own MUTCD.
• Must comply with federal MUTCD.
• Must comply with federal MUTCD changes within 2 years.
• Texas MUTCD: http://www.dot.state.tx.us/trf/mutcd.htm
Part 1: General
• Overall concepts, like:– Purpose– Design– Principles– Placement– Operation– Definitions– Primacy of engineering judgment– Appropriate abbreviations
Part 1: Standard Colors• Black—regulation• Blue—road user services guidance, tourist information, and
evacuation route• Brown—recreational and cultural interest area guidance• Coral—unassigned• Fluorescent Pink—incident management• Fluorescent Yellow-Green—pedestrian warning, bicycle
warning, playground warning, school bus and school warning• Green—indicated movements permitted, direction guidance• Light Blue—unassigned• Orange—temporary traffic control• Purple—unassigned• Red—stop or prohibition• White—regulation• Yellow—warning
Part 2: Signs
• 9 sections
• First section is “general”: again, definitions and housekeeping
• Organized by sign type
Regulatory Signs
• Describe legal requirements to motorist.
• Disregarding sign is usually a violation of law.
Speed Limit
• Speed limit is a regulatory sign
• Standard– “After an engineering study has been made in
accordance with established traffic engineering practices, the Speed Limit sign shall display the limit established by law, ordinance, regulation, or as adopted by the authorized agency. The speed limits shown shall be in multiples of 10 km/h or 5 mph.”
Speed Limit
• Guidance– At least once every 5 years, States and local
agencies should reevaluate non-statutory speed limits on segments of their roadways that have undergone a significant change in roadway characteristics or surrounding land use since the last review.
– No more than three speed limits should be displayed on any one Speed Limit sign or assembly.
– When a speed limit is to be posted, it should be within 10 km/h or 5 mph of the 85th-percentile speed of free-flowing traffic.
Part 3: Markings
• Describes “pavement and curb markings, object markers, delineators, colored pavements, barricades, channelizing devices and islands.”
Part 4: Highway Traffic Signals
• Applies to “any highway traffic signal by which traffic is alternately directed to stop and permitted to proceed.”
• Includes:– Traditional traffic signals.– Pedestrian signals.– Lane-use signals.– Flashing beacons.
Part 5: TCDs for Low Volume Roads
• Mainly recreational, farm-to-market, or county roads.
• Essentially a relaxed set of the prior requirements.