3
Lucitone Digital Print Denture Cure Guide

Lucitone Digital Print Denture · Lucitone Digital Print 10 min + 3-min cool down 10 min + 3-min cool down 26 minutes Arch 1 Arch 2 2 1. Q & A How many appliances can be cured in

  • Upload
    others

  • View
    3

  • Download
    0

Embed Size (px)

Citation preview

Page 1: Lucitone Digital Print Denture · Lucitone Digital Print 10 min + 3-min cool down 10 min + 3-min cool down 26 minutes Arch 1 Arch 2 2 1. Q & A How many appliances can be cured in

Lucitone Digital Print DentureCure Guide

Page 2: Lucitone Digital Print Denture · Lucitone Digital Print 10 min + 3-min cool down 10 min + 3-min cool down 26 minutes Arch 1 Arch 2 2 1. Q & A How many appliances can be cured in

2

Need Help? Email [email protected] or call 800-243-1942 ext 54212.

Cure1. Carefully place up to two (2) dentures arches, occlusal/tooth side facing

up, on the turntable inside the inLab Speedcure™ Processing Unit.

Note: When curing two (2) appliances at one time, position anterior teeth of each appliance toward the center of the turntable.

Caution: Do not cure more than two (2) appliances at a time. This can cause poor tooth bonding and poor fi t in an appliance.

2. Cure times are listed in the chart below and have been pre-programmed in the inLab Speedcure Processing Unit. Select the menu option “Lucitone Digital” and then “Denture Base” or “Try-In.” After one side is cured, fl ip the arch(es) and cure the intaglio/tissue side using the same menu option.

Caution: Handling the appliance before the 3-minute cool down may compromise fi t accuracy.

1st Cure (occlusal side up)

2nd Cure(tissue side up)

Total Time

Lucitone Digital Try-In 10 min + 3-min cool down 10 min + 3-min cool down 26 minutes

Lucitone Digital Print 10 min + 3-min cool down 10 min + 3-min cool down 26 minutes

Arch 1

Arch 2

2

1

Page 3: Lucitone Digital Print Denture · Lucitone Digital Print 10 min + 3-min cool down 10 min + 3-min cool down 26 minutes Arch 1 Arch 2 2 1. Q & A How many appliances can be cured in

Q & A

How many appliances can be cured in the inLab Speedcure Processing Unit at one time? • A maximum of two (2) arches may be processed at one time. Curing more than two arches at a time will compromise final appliance cure.

What alternative curing units may be used? • Only the inLab Speedcure Processing Unit is validated for the Lucitone Digital Print

Denture workflow. Use of other curing units may result in incomplete cure, impact fit, and compromise accuracy.

May the Eclipse® Processing Unit be used to cure Lucitone Digital Print Dentures and Try-Ins? • The Eclipse Processing Unit is acceptable for use; however, the menu texts will differ from

the menu texts stated in the inLab Speedcure Processing Unit and Lucitone Digital Print Denture Instructions for Use. For additional information, please contact Dentsply Sirona Lab, [email protected].

Dentsply Sirona | 570 West College Avenue | York, PA 17401 | 800-243-1942 | dentsplysirona.comDP-00000499 Rev. 0 (01/2020)