7/30/2019 IGT08 - Draft Programme

1/2

The Future of Gas Turbine Technology4th International Gas Turbine Conference

Draft ProgrammeDAY 1 15 October

08:45 09:00 Welcome and Introduction

Technology Trends (Low Emissions/High Efficiency/Fuel Flexibility/RAM)

09:00 09:2009:25 09:45

09:50 10:10

10:10 10:20

Professor Phil Ligrani, Director Thermo-Fluids Laboratory, Oxford UniversityWolfgang Menapace, Director of Project Strategy & Marketing, Siemens

Dave Wallis, Technology Services, RWE nPower

Q&A

10:20 10:50 Coffee Break

Technology Trends

10:50 11:10

11:15 11:35

11:40 12:00

Paul Markham, Chairman, European Gas urbine Insurance Committee

Mark McNeely,Editor, Diesel & Gas Turbine Worldwide: Power Generation Survey & TrendsProfessor Peter Childs, University of Sussex: Creativity in Turbine Design

12:00 12:30 Professor Riti Singh, ETN Board Member

12:30 13:30 Lunch

Cycle Efficiency Condition Monitoring

13:30-14:00

14:00-14:30

14:30-15:00

15:00-15:30

- Design development and testing of an in engine turbine

traverse system.

Anderson, S.J., QinetiQ / Wilson, A.J.W, Rolls Royce

- Flow Characteristics around the Knife Edge of a Labyrinth

Seal revealed using Computational Fluid Dynamics.

B.I. Soemarwoto, National Aerospace Laboratory NLR

- Impact of Sweep and Lean on the Aerodynamic Behaviour

of Transonic Compressor Rotors.

R. Biollo, University of Padova (Italy)

- Tip leakage flow and heat transfer characteristics on

turbine shroud and blade tip.

I. Hassan, Concordia University (Canada)

-Evolution of a site based monitoring strategy for

Optimization, Environment and Efficiency

Improvement on a Gas Turbine driven compressor

station.

M Durcan, Bord Gais ireann / C. Dagnall, Cogsys

- Monitoring blade resonances using microwave tip

clearance sensors.

M. Hafner, Vibro-Meter SA (Switzerland)

- Evaluation of thermo-mechanical fatigue stresses

and residual life: an implemented procedure for on-

line monitoring of a gas-steam power plant.

E. Lo Casto, University of Padova (Italy)

- Ultrasonic manual inspection techniques for gas

turbine R0 compressor blades.

J. M. Berrio, Iberdrola Generacin (Spain)

15:30 16:00 Coffee Break

Fuel Flexibility & Emissions Materials and Structures

16:00-16:30

16:30-17:00

17:00-17:30

- Modeling natural gas turbulent combustion in gas

turbine: Coupling 3D combustion simulations with

Chemical Reactor Network for advanced NOx prediction.

V. Fichet, EDF (France)

- The use of combustion dynamics for condition monitoring

of gas turbines.

H. Laget, Electrabel/Laborelec (Belgium)

- Numerical simulation of unstable and turbulent premixed

combustion of hydrogen and hydrogen containing

methane.

R.J.M. Bastiaans, Eindhoven University of Technology(The Netherlands)

- Life-Limiting Mechanisms of Critical Gas Turbine

Components.

R. van Gestel, Chromalloy (The Netherlands)

- Trends in developing coatings - summary fromInternational GT Forum.

N. Czech, Gas Turbine Forum

- Development of innovative non destructive methods

for TBC coatings and monitoring techniques in the

frame of an Italian R&D programme.

C. Rinaldi, CESI RICERCA (Italy)

7/30/2019 IGT08 - Draft Programme

2/2

DAY 2 16 October

09:00 09:05 Opening

Environmental Policy and Emissions

Chair: Derek Taylor, Senior Advisor, DG TREN, European Commission

09:05 09:25

09:30 09:5009:55 10:15

10:15 10:30

Marianne Wenning, Head of Unit, DG Environment, European Commission

Dr. Rajendra Pachauri, Chair of Intergovernmental Panel on Climate Change, TBCDr. Victor Der, Director, US Department of Energy: U.S. Emission Regulations in NOx & CO2.

Q&A

10:30 11:00 Coffee Break

Fuel Flexibility & Emissions Materials and Structures

11:00-11:30

11:30-12:00

12:00-12:30

- Development of a low-swirl injector for syngas and H gas

turbines.

Robert K. Cheng, Lawrence Berkeley National Laboratory(U.S.)

-Combustion of Syngases: Fundamental Combustion

Studies at Gas Turbine Conditions.

P. Mller/ D. Winkler / T. Griffin, University of Applied

Sciences Northwestern Switzerland, S. Daniele/P. Jansohn, Paul Scherrer Institute

-Co-utilization of biomass and natural gas in existing

power plants through primary steam reforming of natural

gas.

F. Delattin, Vrije Universiteit Brussel (Belgium)

- Blade Lifing with Material and Friction Damping.

J.S. Rao, Altair Engineering (India)

-Analysis and optimization of nonlinear gas-turbine

structures with friction and gaps with respect to

resonance peak forced response.

E.P. Petrov, Imperial College London (UK)

-Operating temperature estimation based on

microstructure evolution of Ni-base superalloys for TG

blades/vanes.

E. Vacchieri, Ansaldo Energia (Italy)

12:30 13:30 Lunch

Cycle Efficiency Condition Monitoring

13:30-14:00

14:00-14:30

14:30-15:00

15:00-15:30

- Performance simulation of a microturbine running on

biofuels.

N. Bloemberg, Delft University of Technology (The

Netherlands)

- Implementation of gas turbine components in the CO2-

free brown coal power plant.

B. Persigehl, RWTH Aachen University (Germany)

- Solarised Gas Turbine Power Systems.

R. Buck, DLR (Germany)

- Off-design performance analysis of existing combinedcycle power plant integrated with parabolic trough solar

field.R. Gabbrielli, University of Pisa (Italy)

- Compressor fields rebuilding for gas turbine

monitoring.

B. Bride, EDF (France)

- Gas path analysis and gas turbine re-mapping.

G. Cerri / C. Salvini / A. Giovannelli, University ofRoma TRE

-Application of different ANN model structures for

sensor validation.

T. Palme, University of Stavanger (Norway)

15:30 16:00 Coffee Break

Future Directions

16:00 16:20

16:25 16:45

Nick Otter,Director of Technology and External Affairs, Alstom Power

Wim Hardeveld, Global Manager Rotating Equipment, Shell Global Solutions

16:45 17:00 Summary and Closing