7/21/2019 How to Develop a Film

http://slidepdf.com/reader/full/how-to-develop-a-film 1/1

How to develop a flm

Prepare your equipment: Film tank, Measuring jug, Thermometer, 3 Measuring cylinders, Timer, Safety goggles and gloves, Film clips

 

"ash out measuring cylinders #ith hot #ater and la$el each #ith masking tape: %eveloper&Stop 'ath&Fi(ative

 

Fill measuring jug #ith #ater at )*+c se thermometer 

Make up your three measuring cylinders %eveloper al#ays needs to $e made fresh -heck to see if there is any ready.made Stop 'athand&or Fi(ative $y the sink This can $e reused again and again so you #ill not need to make it fresh if there is some availa$le

 

%/0/12P/ 45:67 8 9*ml %eveloper ;9*ml #ater 4)*+c7

ST2P '<T= 45:5*7 8 9*ml Stop 'ath 9**ml #ater 4)*+c7

F>?<T>0/ 45:678 9*ml Fi(ative ;9*ml #ater 4)*+c7

-heck the >S2 of your @lm and set your timer to the required development time: 4;** >S2 8 A minutes7 45** >S2 8 5) minutes7 Betyour @lm tank

 

Pour in %eveloper Start timer >nvert your tank for )* seconds, then once every 3* seconds "hen the timer goes oC, empty do#n thesink

Pour in Stop 'ath >nvert for 3* seconds only Pour into large container on sink named DStop 'athE

 

Pour in Fi(ative Start timer for 9 minutes >nvert tank every 59 seconds Pour into large container on sink named DFi(ativeE

Fill the tank #ith #ater and add one drop of #etting agent >nvert several times and pour do#n sink

 

Place tank under a cold running tap 1eave for 59.)* minutes Mean#hile, #ash and tidy up

nravel the @lm carefully and cut in half sing @lm clips, hang the negatives up Bently squeee e(cess #ater oC $et#een clean@ngers