featuring LOVE TO PIECES COLLECTION BY

F R E E P A T T E R N

f e a t u r i n g L O V E T O P I E C E S C O L L E C T I O N B Y M A T H E W B O U D R E A U X

© 2018 Courtesy of Art Gallery Quilts LLC. All Rights Reserved.

Q U I L T D E S I G N E D B Y A G F S T U D I O

LPC-1426 TOPIARY FROST

LPC-2426 TOPIARY FERN

LPC-1421 PIECED BUNCHES COOL

LPC-2421 PIECED BUNCHES WILD

LPC-1424LACED INFINITY

LPC-2425 EFFLORESCENT FUSCHSIA

LPC-1420 ANTHONEM SERENE

LPC-2420 ANTHONEM FESTIVE

LPC-1423 STRIPED FLOW MARINE

LPC-2423 STRIPED FLOW RAINBOW

LPC-1428 MANDALA DROPS MIDNIGHT

LPC-2428 MANDALA DROPS IRIS

LPC-1422 REAP AND SEW AZUL

LPC-2422 REAP AND SEW LIGHT

LPC-1427 GLADIOLUMNS INBLUEM

LPC-2427 GLADIOLUMNS PINKBLUEM

F A B R I C S D E S I G N E D B Y M A T H E W B O U D R E A U X

ar tga l le ry fabr ics.com

FINISHED SIZE 78.5" x 87"

FABR IC REQUIREMENTS

CUTT ING D IRECT IONS

¼" seam allowances are included.WOF means width of fabric.

CONSTRUCT ION

Sew all rights sides together with ¼"seam allowance.

•The Quilt top is made out of two equal sections

Each section consist of twenty nine (29) rows Each row is made out of thirty one (31) half hexies. (both sections are exactly the same)

•Alternate the direction of each piece following diagram below,BACKING FABRIC

LPC-2423 (Fabric G) 6 yds. (Suggested)

BINDING FABRIC LPC-2426- (Fabric E) (included)

Fabric A LPC-1424 1 5/8 yd. Fabric B DEN-S 2004 1/6yd. Fabric C LPC-2425 1 1/4 yd. Fabric D LPC-2428 ⅓yd. Fabric E LPC-2426 ⅞ yd. Fabric F PE-426 ⅜ yd. Fabric G LPC-2423 ½ yd. Fabric H LPC-1420 �∕� yd. Fabric I LPC-1428 ⅝ Yd Fabric J LPC-1422 ⅓ Yd. Fabric K LPC-2420 ⅛ yd. Fabric L LPC-1421 �∕� Yd. Fabric M PE-428 3 �∕�Yd.

Sew

Small part of hexie pointing

down

Wider part of hexie pointing

down

• One hundred and thirty two (132) templates from fabric J

• One hundred and wight (108) templates from fabric K

• Sixteen (16) templates from fabric L

• Six hundred and fifty eight (658) templates from fabric M

• Two hundred and ninety four (294) templates from Fabric A

• Sixteen (16) templates from fabric B

• Two hundred and thirty four (234) templates from fabric C

• Forty eight (48) templates from fabric D

• Seventy Two (72) templates from fabric E

• Fifty six (56) templates from fabric F

• Sixty two (62) templates from fabric G

• One hundred and thirty two (132) templates from fabric H

• One hundred and wight (108) templates from fabric I

DIAGRAM 1


DIAGRAM 2

•Follow diagram below 2 for fabric arrangement by row,


•Follow diagram below for each row assembly

ASSEMBL ING THE TOP

DIAGRAM 3


•After all rows were sewn together. Repeat construction step following diagram 2 and 3 one more time, until you have the two sections as shown on diagram 4 ,

• Reflected the second block and sew together.

DIAGRAM 4


•Trim the sides of the quilt to a 78.5"" x 87'"


QUILT ASSEMBLY

Sew rights sides together.

•Place BACKING FABRIC on a large surface wrong side up. Stretch it with masking tape against that surface.

•Place BATTING on top of backing fabric.

•Place TOP on top of the batting with right side facing up. Smooth away wrinkles using your hands.

•Pin all layers together and baste with basting thread, using long stitches. You can also use safety pins to join the layers.

•Machine or hand quilt starting at the center and working towards the corners. Remember that quilting motifs are a matter of personal preference. Have fun choosing yours!

•After you finished, trim excess of any fabric or batting, squaring the quilt to proceed to bind it.

B IND ING

Sew rights sides together.

• Cut 9 strips 1½" wide by the width of the fabric E to make a final strip 344" long. Start sewing the bind-ing strip in the middle of one of the sides of the quilt, placing the strip right side down and leaving an approximated 5" tail. Sew with ¼" seam allow-ance (using straight stitch), aligning the strip’s raw edge with the quilt top’s raw edge.

• Stop stitching ¼" before the edge of the quilt (DIA-GRAM B 1). Clip the threads. Remove the quilt from under the machine presser foot. Fold the strip in a motion of 45° and upward, pressing with your fingers (DIAGRAM B2). Hold this fold with your finger, bring the strip down in line with the next edge, making a horizontal fold that aligns with the top edge of the quilt (DIAGRAM B3). Start sewing at ¼" of the bor-der, stitching all the layers. Do the same in the four corners of the quilt.

• Stop stitching before you reach the last 5 or 6 inches. Cut the threads and remove the quilt from under the machine presser foot. Lay the loose ends of the binding flat along the quilt edge, folding the ends back on themselves where they meet. Press them together to form a crease. Using this crease as the stitching line, sew the two open ends of the bind-ing with right sides together (you can help yourself marking with a pencil if the crease is difficult to see).

• Trim seam to ¼" and press open. Complete the sew-ing. Turn binding to back of the quilt, turn raw edge inside and stitch by hand using blind stitch.

45˚

DIAGRAM B2

DIAGRAM B1Stop stitching here

DIAGRAM B3 fold

NOTE: While all possible care has been taken to ensure the accuracy of this pattern, We are not responsible for printing errors or the way in which individual work varies.Please read instructions carefully before starting the construction of this quilt. If desired, wash and iron your fabrics before starting to cut.

a r tga l le ry fabr ics.com

© 2018 Courtesy of Art Gallery Quilts LLC. All Rights Reserved.


TEMPLATE

Documents

featuring LOVE TO PIECES COLLECTION BY