2
Valor Fireplaces • 190—2255 Dollarton Highway • North Vancouver, BC • V7H 3B1 Tel: 604.984.3496 or 1.800.468.2567 • Fax: 604.984.0246 or 1.800.268.0333 www.valorreplaces.com December 2019 1/2 Concept L2 1700K Mantel—See Installation Manual Hearth: not required. If used, must be minimum 4” below replace opening unless using HeatShift (see “Appendix D— HeatShift™System” in Installation Manual). Surrou d nd Pl late w with Barrier Screen ( required) Narr row 1” Trim 1775LFB and wide er 3-1/2” steel Trim 1750 adjus stable, accept additional non- -combustible f inish over cement board and behind trim. 1730CIK’s narrow trim requires HeatShif t. Cem ent board f inishes up to perimeter of trim. Note: 1730CIK installs before cement bo b ard. 1700K heater Combustible Floor Framing—See Installation Manual 1/2 inch thick non-combustible cement board –NOT supplied Supplied as vertical outlet, eld convertible to horizontal outlet. Note - Vertical rise required in vent system Optional HeatShift System outlets (4)—Required with 1730CIK Remote Handset Wall Holder Electrical junction box (not supplied) to connect power when using optional fan, WiFi Wall ll Fi ini ish h A Any wall f inishes applied o over cement board must be non-combustible. Com mbustible mantel are ok p rovided they conform to Installation Manual Combustible Framing Allowed Beneath Fireplace. When the appliance is installed directly on carpeting, tile or other combustible material other than wood ooring, the appliance shall be installed on a metal or wood panel extending the full width and recessed depth of the appliance. Remote Battery and Wall Switch Kit (required) (35-foot wire length) (supplied) Note: This appliance may be installed in outdoor, weather protected environments as dened in the GV60CKO Outdoor Conversion Kit instruction manual.

1700K Concept & Dimensions Dec-2019 - Valor Fireplaces

  • Upload
    others

  • View
    2

  • Download
    0

Embed Size (px)

Citation preview

Page 1: 1700K Concept & Dimensions Dec-2019 - Valor Fireplaces

Valor Fireplaces • 190—2255 Dollarton Highway • North Vancouver, BC • V7H 3B1Tel: 604.984.3496 or 1.800.468.2567 • Fax: 604.984.0246 or 1.800.268.0333

www.valorfi replaces.com

December 20191/2

ConceptL2 1700K

Mantel—See Installation Manual

Hearth: not required. If used, must be minimum 4” below fi replace opening unless using HeatShift (see “Appendix D—HeatShift™System” in Installation Manual).

Surrou dnd Pllate wwith Barrier Screen

(required)Narrrow 1” Trim 1775LFB andwideer 3-1/2” steel Trim 1750

adjusstable, accept additional non--combustible finish over

cement board and behind trim.

1730CIK’s narrow trim requires HeatShift.

Cement board finishes up to perimeter of trim.

Note: 1730CIK installs beforecement bob ard.

1700K heater

Combustible Floor

Framing—See Installation Manual

1/2 inch thick non-combustible cement board –NOT suppliedSupplied as vertical outlet, fi eld convertible to horizontal outlet. Note - Vertical rise required in vent system

Optional HeatShift System outlets (4)—Required with 1730CIK

Remote Handset

Wall Holder

Electrical junction box (not supplied) to connect power when using optional fan, WiFi

Wallll FiiniishhAAny wall finishes applied oover cement board must

be non-combustible.Commbustible mantel are ok

provided they conform to Installation Manual

Combustible Framing Allowed Beneath Fireplace. When the appliance is installed directly on carpeting, tile or other combustible material other than wood fl ooring, the appliance shall be installed on a metal or wood panel extending the full width and recessed depth of the appliance.

Remote Battery and Wall Switch Kit (required) (35-foot wire length) (supplied)

Note: This appliance may be installed in outdoor, weather protected environments as defi ned in the GV60CKO Outdoor Conversion Kit instruction manual.

Page 2: 1700K Concept & Dimensions Dec-2019 - Valor Fireplaces

Valor Fireplaces • 190—2255 Dollarton Highway • North Vancouver, BC • V7H 3B1Tel: 604.984.3496 or 1.800.468.2567 • Fax: 604.984.0246 or 1.800.268.0333

www.valorfi replaces.com

December 20192/2

DimensionsL2 1700K

CenterLiLine

57-3/4” [ 1467 mm]

18”

[457

mm

]

15-1

/16”

[383

mm

]

19-7

/8”

[505

mm

]

52” [ 1321 mm]

HeatShift System outlets (remove plates)

Gas LineAccess Point

Zero Clearance

3-3/4”[95 mm]

4”[102 mm] 32

-3/8

” [82

2 m

m]

14-1/22” [369 mmm]

9-3/8”” [238 mmm]

49-11/16” [ 1262 mm]1270RBK RemoteBlower Kit outlet (remove plate)

Zero Clearance Zero Clearance

88” [2235 mm]

62-1

/4” [

158

1 m

m]

20-1/2”[519 mm]

Zero Clearance Face of Framing

Front ViewLeft Side View Right Side View

Corner Dimensions

Top View

Min

. 44

-1/2

” [ 1

130

mm

]to

top

of c

emen

t boa

rd

Min

. 43

” [ 1

092

mm

]to

und

ersi

deof

head

er

ElectricalEl t i lInlet Point

Header

6-5/8” dia. Venting

convertiblefrom top torear outlet

Center of vent

15-1/16”mm][383

33-1

/8” [

841

mm

]

1270RBK RemoteBlower Kit outlet (remove plate)