Valor Fireplaces • 190—2255 Dollarton Highway • North Vancouver, BC • V7H 3B1Tel: 604.984.3496 or 1.800.468.2567 • Fax: 604.984.0246 or 1.800.268.0333
www.valorfi replaces.com
December 20191/2
ConceptL2 1700K
Mantel—See Installation Manual
Hearth: not required. If used, must be minimum 4” below fi replace opening unless using HeatShift (see “Appendix D—HeatShift™System” in Installation Manual).
Surrou dnd Pllate wwith Barrier Screen
(required)Narrrow 1” Trim 1775LFB andwideer 3-1/2” steel Trim 1750
adjusstable, accept additional non--combustible finish over
cement board and behind trim.
1730CIK’s narrow trim requires HeatShift.
Cement board finishes up to perimeter of trim.
Note: 1730CIK installs beforecement bob ard.
1700K heater
Combustible Floor
Framing—See Installation Manual
1/2 inch thick non-combustible cement board –NOT suppliedSupplied as vertical outlet, fi eld convertible to horizontal outlet. Note - Vertical rise required in vent system
Optional HeatShift System outlets (4)—Required with 1730CIK
Remote Handset
Wall Holder
Electrical junction box (not supplied) to connect power when using optional fan, WiFi
Wallll FiiniishhAAny wall finishes applied oover cement board must
be non-combustible.Commbustible mantel are ok
provided they conform to Installation Manual
Combustible Framing Allowed Beneath Fireplace. When the appliance is installed directly on carpeting, tile or other combustible material other than wood fl ooring, the appliance shall be installed on a metal or wood panel extending the full width and recessed depth of the appliance.
Remote Battery and Wall Switch Kit (required) (35-foot wire length) (supplied)
Note: This appliance may be installed in outdoor, weather protected environments as defi ned in the GV60CKO Outdoor Conversion Kit instruction manual.
Valor Fireplaces • 190—2255 Dollarton Highway • North Vancouver, BC • V7H 3B1Tel: 604.984.3496 or 1.800.468.2567 • Fax: 604.984.0246 or 1.800.268.0333
www.valorfi replaces.com
December 20192/2
DimensionsL2 1700K
CenterLiLine
57-3/4” [ 1467 mm]
18”
[457
mm
]
15-1
/16”
[383
mm
]
19-7
/8”
[505
mm
]
52” [ 1321 mm]
HeatShift System outlets (remove plates)
Gas LineAccess Point
Zero Clearance
3-3/4”[95 mm]
4”[102 mm] 32
-3/8
” [82
2 m
m]
14-1/22” [369 mmm]
9-3/8”” [238 mmm]
49-11/16” [ 1262 mm]1270RBK RemoteBlower Kit outlet (remove plate)
Zero Clearance Zero Clearance
88” [2235 mm]
62-1
/4” [
158
1 m
m]
20-1/2”[519 mm]
Zero Clearance Face of Framing
Front ViewLeft Side View Right Side View
Corner Dimensions
Top View
Min
. 44
-1/2
” [ 1
130
mm
]to
top
of c
emen
t boa
rd
Min
. 43
” [ 1
092
mm
]to
und
ersi
deof
head
er
ElectricalEl t i lInlet Point
Header
6-5/8” dia. Venting
convertiblefrom top torear outlet
Center of vent
15-1/16”mm][383
33-1
/8” [
841
mm
]
1270RBK RemoteBlower Kit outlet (remove plate)
Recommended
