Page 1 of 2

VRL4543 SERIES

P/N 900628-01, REV. A, 10/2016

Firep

lace D

imen

sionsVENT-FREE FIREPLACES

Fram

ing Di

men

sions

Diagrams, illustrations and photographs are not to scale. Consult installation instructions. Product designs, materials, dimensions, specifications, colors, and prices are subject to change or discontinuance without notice.

53-1/4"

38"(966 mm)

17-1/2" (445 mm)Mounted inside of nailing flange (flat)

For one sided application, studs are not mounted to the rear of nailing flanges Studs mounted (flat)

inside of nailing flange

(1353 mm) 53-1/4"

38"(966 mm)

15-1/4" (388 mm)

(1353 mm)

Framing Dimensions for One Sided Application Framing Dimensions for See-Thru Application

Gas LineAccess

(both sides)

Electrical Outlet is on the opposite side

5/8"(16 mm)

11 3/4"(298 mm)

16 1/2"(419 mm)

8 1/4"(210 mm)

29 5/8"(753 mm)

29 5/8"(753 mm)

16 3/8"(416 mm)

7 1/8"(181 mm)

1 7/8"(48 mm)

8 1/4"(210 mm)

44 1/8"(1121 mm)

55 1/8"(1400 mm)

47"(1194 mm)

1"(26 mm)

1"(26 mm)

52"(1321 mm)

17 1/2"(445 mm)

Printed in U.S.A. © 2016 Innovative Hearth ProductsP/N 900628-01 REV. A 10/2016 Page 2 of 2

Clear

ance

sVRL4543 SERIES

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Minimum clearances to combustibles for the fireplace are as follows:

*Back and Sides 1” 26 mm

Perpendicular Walls 8” 203 mm

Floor (from bottom of fireplace) 0” 0 mm

Ceiling (from top of opening) 42” 1067 mm

Top of Standoffs 0” 0 mm

These appliances comply with National Safety Standards and are listed by PFS Corporation to ANSI Z21.11.2 as unvented Gas-fired room heaters.

PFS ®

USC

Report No. F11-054

*For back and sides of fireplace, do not pack with insulation or other materials.

Prod

uct In

fo

Listin

g

Cat. No. Model Weight Cu. Ft.

F1186 VRL4543ZEN 276 lb 24.5

F1187 VRL4543ZEP 276 lb 24.5

MantelClearance

Ref. MantelDepth

Ref. Mantel from Top of Opening

1. 12 (305) A 24 (610)2. 9 (229) B 21 (554)3. 6 (152) C 18 (458)4. 4 (102) D 16 (407)5. 2 (51) E 14 (356)

Side Wall Clearance

Inches (millimeters)

AB C

D E

1

2345

Wall

Supplied firebox hood must be used at all times

Noncombustible material may project off this surface above the firebox hood

FireplaceSide View

NOTE: All vertical measurements are from top of fireplace hood opening to bottom of mantel shelf.

8"(204 mm)

CombustibleMaterial MayBe Used

TOP VIEW

SAFEZONE

PerpendicularWall

33°

4" (102 mm) toFace Opening 5"

(127 mm)

FireplaceTop View

Specifications and clearances are subject to change without notice. Refer to Installation Manual before installation of these appliances for updated dimensions and instructions.

Faca

de Di

men

sions

Optional Facade Kits

Cat. No. Model Description

F1036 DFT43B Decorative Face Trim, Black

F1037 DFT43AS Decorative Face Trim, Aged Silver

F1038 DFT43AC Decorative Face Trim, Aged Copper

30-5/8”58-1/2”