Upload
bestlaminate-inc
View
5.306
Download
0
Embed Size (px)
DESCRIPTION
This illustrated guide will show you with detailed step-by-step pictures how to install Silver Vapor 3-in-1 Flooring Underlayment. (Available here: http://ow.ly/yCiNz)
Citation preview
How To Install Silver Vapor 3-in-1 Flooring Underlayment
Make it a DIY Project and save on your floor installation cost
Fact: Laying down underlayment is 10% of your installation cost
You may need: Enough vapor 3-in-1, Flooring, broom & dust pan, tape, scissors/utility knife
Step 1: Get cleaning! Subfloor should be clean and free of dirt.
Step 2: Subfloor check – subfloor should be in good condition without damages
Step 3: Fix Subfloor – subfloor needs fixing if: It is sloping, has excessive gabs, cracks or any areas with moisture.
Step 4: Time to get started – roll out vapor underlayment with the silver side facing down.
Quick hint: Overlapping film should be towards open room & Tape strip next to wall
Step 5: Install Parallel to the wall
Step 6: Cut your measured section with a utility knife
Step 7: You may add tape to temporally hold underlayment in place
Step 8: Install flooring on the underlayment section already installed
Cross stack your flooring – make sure to acclimate your flooring at least 48 hours before the installation
Step 9: Start your new roll – repeat step 4 and start your next roll
Step 10: Measure and Pre-cut next section
Step 11: Combine edges - butt edges together making sure to overlap only the silver film
Step 12: Remove adhesive layer and stick to underlament
Step 13: Use additional tape to secure rows if needed
Step 14: Continue Installation according to manufacturers instructions
Connect with us : www.bestlaminate.com / Facebook.com/Bestlaminate / Twitter.com/Bestlaminate
www.Bestlaminate.com
Facebook.com/Bestlaminate
Twitter.com/Bestlaminate