OFDMA Presentation

Multi-carrier transmission & OFDM

Presented to : Dr. Salwa El RamliPrepared by : Amr Mohamed

2

1)Multi carrier transmission:

1.1)Multi carrier transmission.

1.2)drawbacks.

2)OFDM:

2.1)Basic principles.

2.2)OFDM & FDM.

2.3)OFDM modulation

2.4)OFDM demodulation.

2.5)OFDM implementation using IFFT/FFT.

2.6)Cyclic prefix.

2.7)Frequency domain model.

2.8)Frequency diversity.

2.9)Selection of OFDM parameters.

2.10)OFDMA.

3

1.1)Multi carrier transmission:

Multi carrier transmission

4

1.2)Draw backs :

1- We cant make tight subcarrier

spacing “ decrease BW efficiency”.

2- Larger variations in the instantaneous transmit power similar to higher order modulation.

“high cost power amplifier & high power consumption.

Multi carrier transmission

5

2.1)Basic principles:

OFDM

6

2.2)OFDM & FDM :OFDM is special case of FDM, the following figures shows what are the difference between Regular FDM-single carrier and OFDM.

OFDM

7

2.3)OFDM modulation:

OFDM

8

Choosing the no. of subcarriers and the spacing depends on channel conditions.

Given (BW and freq. spacing) we can find the number of subcarriers.

Ex: spacing =15 khz& BW=10 Mhz 600 subcarrier.

The word OFDM subcarriers are mutually orthogonal over the time interval mTu ≤t <(m+1)Tu .

9

Basic OFDM transmission can be seen as the modulation of a set of orthogonal functions

OFDM

10

The ‘physical resource’ in case of OFDM transmission is often illustrated as a time–frequency grid according to Figure 4.4 where each ‘column’ corresponds to one OFDM symbol and each ‘row’ corresponds to one OFDM subcarrier.

OFDM

11

Example of the OFDM signal transmitted versus time.

OFDM

12

2.4)OFDM demodulation:

OFDM

13

2.5)OFDM implementation using IFFT/FFT:

OFDM

14

•Any corruption of the frequency-domain structure of the OFDM subcarriers, e.g. due to a frequency selective radio channel, may lead to a loss of inter-subcarrier orthogonality and

thus to interference between subcarriers

•What is the SOLUTION ? ? ? ?

OFDM

15

2.6)Cyclic prefix: In case of time-dispersive channel the orthogonality between the subcarriers will, at least partly be lost, Due to inter-symbol interference within a subcarrier and interference between subcarriers.

Have in mind that time dispersion on the radio channel is equivalent to a frequency-selective channel frequency response.

A relatively modest radio-channel frequency selectivity may cause non-negligible interference between subcarriers, Due to the relatively large side lobes of each OFDM subcarrier.

OFDM

16

2.6)Cyclic prefix:

OFDM

17

2.6)cyclic prefix: Cyclic-prefix insertion thus increases the length of the

OFDM symbol from Tu to Tu +TCP, with a reduction in the OFDM symbol rate.

Also increasing the samples length from N to N +NCP.

Cyclic prefix is beneficial as long as the span of the time dispersion does not exceed the length of the cyclic prefix.

OFDM

18

2.6)Cyclic prefix: The drawback of cyclic-prefix insertion is that only a fraction Tu/(Tu +TCP) of the received signal power is actually utilized by the OFDM demodulator

There is a trade-off between the power loss due to the cyclic prefix and the signal corruption.

Time dispersion typically increases with the cell size, beyond a certain cell size there is no reason to increase the cyclic prefix further as the corresponding power loss due to a further increase of the cyclic prefix would have a larger negative impact.

OFDM

19

bk is the transmitted modulation symbol ak scaled and phase rotated by the complex frequency-domain channel tap Hk and impaired by noise nk.

2.7)Frequency domain model:

OFDM

20

To properly recover the transmitted symbol for further processing, for example data demodulation and channel decoding, the receiver should multiply bk with the complex conjugate of Hk.

OFDM

21

Reference symbols, sometimes also referred to as pilot symbols to estimate HUsing knowledge about the reference symbols,the receiver can estimate the frequency-domain channel around the location of the reference symbol to use it in the receiver.

OFDM

22

2.8)Frequency diversity:

OFDM

23

2.9)Selection of basic OFDM parameters:

2.9.1)Subcarrier spacing

2.9.2)Number of subcarriers

2.9.3)T =TCP +Tu or equivalently OFDM symbol rate.

OFDM

24

2.9) Selection of basic OFDM parameters: The OFDM subcarrier spacing should be as small as possible to minimize the relative cyclic-prefix overhead TCP/(Tu +TCP).

too small subcarrier spacing increases the sensitivity of the OFDM transmission to Doppler spread and different kinds of frequency inaccuracies.

OFDM

25

Variations in instantaneous power:

OFDM

26

2.10)OFDMA :

OFDM

27

SINRtarget at a Throughput = 500 kbps for different channel models:

28

SINRtarget(UL) VS ( Nrb.UL & throughput) @ epa5:

29

SINRtarget (UL)VS ( Nrb.UL & throughput) @ eva70: