www.rubbermachineryworld.com Internal Mill Selection Questionnaire Page 1 of 1

INTERNAL MIXER SELECTION QUESTIONNAIRE

Criterion Please Answer as Descriptively as Possible

Production Requirement: ___________________ Tons/Hour ; ___________________ of 8 hour Shifts/Day

What is your compound requirement? (Please tick)

Single Stage Mixing Double Stage Mixing Others If Others, please specify:

Type of Mixer: (Please tick) Tangential (Banbury® Type) Intermeshing (Intermix® Type)

Mixer Capacity: (Optional) ___________________ Liter

Rotor Type: (if Tangential) 2-Wing 4-Wing (usually for >160 Liter Mixers Only) 6-Wing (usually for >270 Liter Mixers Only)

Proposed for: (Please tick)

Master Batch Finals Both Others If Others, please specify:

Rotor Speed for Mixing: (RPM) (Please fill and tick)

___________________ RPM; VFD Motor Required for variable speed

Hopper Preference Pneumatic Ram Hydraulic Ram

Gearbox (Please tick)

Unidrive (Gearbox to have single input shaft/double output shaft) Semi Unidrive (Connecting Gear on Mixer)

If you have any Service Factor (SF) specifications, note here or discuss with the manufacturer without fail.

Details on any major components that are of abrasive or heat sensitive nature in your recipe (Required for correct material selection and wear protection technology)

Any other inputs you wish to share on your need. (For example, brands of electrical, hydraulic components, or lubrication requirements, etc - Optional)