Upload
robin-huang
View
381
Download
0
Embed Size (px)
Citation preview
UniGuard Technology Limited
www.uniguardgps.com
To make clients understand better about UT04 vehicle fuel monitoring connection, we ask
one client to explain in details how he does installation. We appreciate a lot.
Steps about fuel monitoring lines connection and calibration:
Vehicle fuel pump usually have 5 or 6 wires.
1.Turn on vehicle ACC, use a multimeter to measure the wires.
2.Some wires give a definite voltage, some does not give, the fuel sensor wire gives a low
voltage.
3.After the sensor wire is found, it is peeled and connected to tracker Fuel check line.
Above is about connection, after this, you need do calibrations either by SMS command or
tracking software. Below is done via web or pc tracking software.
1 Login web or pc tracking software, click Send Scheduling Instructions and then follow
according to the picture. Tracker will reply a measure value. Record the value. E.g.
Measure value is 80
2 Go to read the fuel amount from vehicle Fuel meter meanwhile. E.g. the Fuel Meter
shows 75%
3 Here we get voltage value is 80 and fuel amount value is 75%
4 Open the Fuel Table Manager as below picture and fill in the measure voltage value
and fuel amount value.
UniGuard Technology Limited
www.uniguardgps.com
5 Keep sending commands when fuel meter shows 100%, 50% and 25%. You will get
totally 4 measured voltage value accordingly. Fill in the Fuel Table Manager.
6 Exit the software and re-login. If you login PC tracking software, please click
Control-Refresh Local Data
You can also refer to following links for help
Fuel Monitoring Step by Step http://www.uniguardgps.com/Support/Faqs/105.html
How does fuel monitoring work http://www.uniguardgps.com/Support/Faqs/21.html