Click here to load reader
Upload
hellenll
View
33
Download
1
Embed Size (px)
DESCRIPTION
Today, I’m going to share with you a unique jewelry designs on how to make necklaces with semi-precious gemstones, brass wire and pieces of decorative round seed beads.
Citation preview
Unique Jewelry Designs-Make Necklaces out of
Brass Wires
Instead of shopping in the mall or looking for unique
jewelry designs online, make your own and be artistic!
Make necklaces using inches of durable and soft jewelry
wire and beads to help create numerous striking
accessories that coordinate with your wardrobe. Follow
the instructions and have an original beaded necklace
ready to wear in an hour.
Supplies needed to make necklaces:
4mm Round Seed Bead
Flat-oval Gemstone
Brass Wire
Hammer
Iron Block
Round Nose Pliers
Side Cutting Pliers
Flat Nose Pliers
Details of this unique jewelry designs:
: Flatten one end of the wire, and then Step 1
curve the part into a “croissant” around round nose
pliers.
Today, I’m going to share with you a unique jewelry designs on how to make necklaces with semi-precious
gemstones, brass wire and pieces of decorative round seed beads.
: Slide on one gemstone bead and Step 2
bend the wire upwards 90 degrees.
: Bend the wire tail down 5mm. Take Step 3
another strand of wire and do the “croissant” at
one end as before. Feed the wire with the bead
through the “croissant” of the next link.
Get inspired, and then make necklaces by combining the three types of supplies in masterful and
artful methods that adorn your neck in elegance. Just follow the guides and try being creative as
possible as you can! For more kinds of unique jewelry designs, you may refer to LenaMer’s shop at:
www.lenamer.etsy.com. Enjoy yourself!
Jewelry tools needed during your handcraft making please click:
http://www.pandahall.com/beads/wholesale-Jewelry-Tools/0-109-1.html
: Make a small loop below and remove Step 4
leftover with pliers. Decorate with one 4mm
seed bead dangler.
: Repeat the above steps to create the Step 5
basic components of the necklace.
: When it reaches the desired length, Step 6
connect the start and end and that’s it!