A CONNECTING SKINNED WIRES TO WIRING MATERIALS

Your name

OBJECTIVE: To be able to properly connect skinned wires to bulb receptacles,convenience outlets, switches, or any other wiring materials.• TOOLS• Combination pliers• Side cutting pliers• Long nose pliers• 4. Wire stripper• 5. Electrician’s knife• 6. Phillips screw drivers• 7. Flat screw drivers

• MATERIALS:• Electrical wires used in Activity 1.1

PROCEDURE:

• Electrical wires used in Activity 1.1

1. Make terminal loops using long nose pliers from your skinned wires of about 1 to 1 ½ inches long.

2. Connect the skinned wire to screw terminals of the bulb receptacle.*Be sure that the wire loop is to be connected or attached to the terminal screw in clockwise direction.

3. Insert the loop to the screw and tighten it to the convenience outlet.*Be sure that the wire loop is to be connected or attached to the terminal screw in clockwise direction.

4. Insert the loop to the screw of the switch and tighten it.*Be sure that the wire loop is to be connected or attached to the terminal screw in clockwise direction.

5. Insert the loop to the screw of the fuse terminal and tighten it.*Be sure that the wire loop is to be connected or attached to theterminal screw in clockwise direction.