AutoCAD 2D1
By : Cesar Mendoza
Draw the Borderline and Title Block
200
265
330
15
15BORDER
NAME: TITLE: SECTION: DATE: SCALE
100
Drawing frame
Title block
Draw border line 15mm from edge of paper
15 mm
Draw title block 15 mm away from bottom border line
100 mm200 mm
265 mm
330 mm
Draw guideline for the title block: Name, title, section
100 mm200 mm
265 mm
330 mm
Draw the dividing line for the working space
200 mm
Draw the dividing line for the working space
200 mm
Write your name and complete the inforamtion in the title block
MOHAMMED AL SHAMSI
Get the center of the working space by striking thin diagonal line from the corner
200 mm
Draw the Circle with radius 45mm
Draw the centerline (long short stroke) of the circle
Draw a 45 degree diagonal line passing to the center of the circle
Draw the broken line and make a square passing to the diagonal lines.
Draw the first “V” inside the circle, vertex on the horizontal line (use thick line or object line)
Draw the second “V” inside the circle, vertex on the vertial line (use thick line or object line)
Make another “V” on the vertical line
Lastly,make the last “V” on the horizontal line
Make a square with the corners on the horizontal and vertical centeline
Locate center of the working space on the second box by striking thin diagonal line from the corner
200 mm
From the center measure 50mm below and construct a thin line
50 mm
From the center line make a 50 mm thick line
50 mm
From the end of the line strike arc to get the center of the circle
From the other end of the line strike arc to get the center of the arc.
Draw the circle of the hexagon
From the end the line strike arc to get the point of the hexagon
From the end strike arc to get the point of the hexagon
From the end strike arc to get the point of hexagon
From the end strike arc to get the point of the hexagon
Connect the corner points of the hexagon (use thick line)
Connect the corner points of the hexagon (use thick line)
Connect the corner points of the hexagon (use thick line)
Recommended
