A6a to A6bSchematic Diagram
to
Pictorial Diagram
Turn to page A6a and A6b in the Student
Handout Packet. If you have NOT viewed the
power point presentation entitled ‘glow coil’,
please do so BEFORE you continue on with this
schematic to pictorial.
You will now draw the
Pictorial
by following the
Schematic
Follow the schematic to wire the pictorial.
Please complete YOUR page A6b as you
proceed through the following slides.
24v from the ‘P’ terminal goes to the ‘R’ terminal of the terminal strip, then to the thermostat and back from the thermostat to the ‘W’ terminal of the terminal strip.
P C
Please mark the P and C terminals on the control transformer.
P C
There is NO terminalstrip so go directly tothe thermostat.
P C
24v continues on to the ‘Fan Time Delay Switch.’
P C
P C
24v continues on to the ‘Limit Switch.’
P C
P C
24v continues on to the gas valve.
P C
P C
24v continues from the gas valve to the NO terminal of the Baso switch, which they are calling the ignitor relay (same thing).
P C
P C
We are going to back up and start again at the ‘P’ terminal of the control transformer. We come out of the ‘P’ terminal and go to the ‘Pilot Pressure Switch.’
P C
P C
P C
We come out of the pilot pressure switch and go to the ignition transformer primary.
P C
P C
We come out of the primary of the ignition transformer and go to the NC terminal of the Baso switch.
P C
P C
We come out of the C terminal of the Baso and go to the C terminal of the control transformer.
P C
P C
Add two wires from the ignition transformer to the ignitor (glow coil).
P C
You have finished the
heating low voltage circuits
pictorial
following a
schematic