1
IEEE 802.16Wireless MAN(Wireless Metropolitan Network)
“A Technical Overview of the WirelessMANTM Air Interface for Broadband Wireless Access“, Carl Eklund, Roger B.
Marks, Kenneth L. Stanwood and Stanley Wang June 2002
Presented by Phuong NguyenFor 681 Advanced Computer Network Fall 2007
2
Topics
Introduction Physical Layer MAC Layer (Medium Access Control)
References
3
Introduction
Goal: Provide high-speed Internet access to home and business subscribers, without wires.
Base stations (BS) can handle thousands of subscriber stations (SS) BS can control all data traffic goes between BS and SS through the
allocation of bandwidth on the radio channel. 802.16 is a Bandwidth on Demand system Access control prevents collisions. Supports
Legacy voice systems Voice over IP TCP/IP Applications with different QoS requirements.
Main advantage : fast deployment, dynamic sharing of radio resources and low cost
4
5
Architecture
Uplink: direction from SS to BS
Downlink: direction from BS to SS
Source: D. Miorandi Create Net
6
IEEE 802.16 Extension 802.16 standard was approved in 2001 802.16.1 (10-66 GHz, line-of-sight, up to 134Mbit/s) 802.16.2 (minimizing interference between coexisting WMANs.) 802.16a
Support lower frequency 2 to 11Ghz both licensed and license-exempt So reach more customers with less expensive Lower data rates Support Mesh-Network
802.16b Increase spectrum to 5 and 6GHz Provide QoS (for real-time voice and video service)
802.16c Represents a 10 to 66GHz system profile
802.16d Improvement and fixes for 802.16a
802.16e Addresses on Mobile Enable high-speed signal handoffs necessary for communications with users
moving at vehicular speeds Focus on 802.16.1
7
SAP: Service Access Point
PDU: Protocol Data Unit
Accept, perform classification, process higher PDUsDeliver CS PDU to MAC SAPReceive CS PDUs from the peer entity
System access, bandwidth allocationconnection establishment, connection maintenance
Authentication, security key exchange, encryption
IEEE Std 802.16 protocol layering, showing SAPs
Multiple specifications each appropriate to frequency range (ex: 802.16.1 10-66GHz up to 134Mbit/s) and application
8
Physical layer
10-66GHz line of sight propagation. US use 20-25MHz, EU use 28MHz
Point – to – multipoint BS transmit a TDM (Time Division Multiplexing) signal with individual SSs allocated time slots serially
Access the uplink by time division multiple access (TDMA) ”Burst single-carrier” modulation Allows use of directional antennas Allows use of two different duplexing schemes:
Frequency Division Duplexing (FDD) Time Division Duplexing (TDD)
Support for both full and half duplex stations
9
Time Division Duplexing (TDD)
Uplink and downlink share a channel but do not transmit simultaneously
Source: D. Miorandi Create Net
10
Frequency Division Duplexing (FDD)
Uplink and downlink operate on separate channels sometime simultaneously
Support full duplex SSs which can transmit and receive simultaneously
Half duplex which do not Adaptive Data Burst Profiles
Transmission parameters (e.g. modulation and FEC settings) can be modified on a frame-by-frame basis for each SS.
Profiles are identified by ”Interval Usage Code” (DIUC and UIUC)
Using both TDM (Time Division Multiplexing) and TDMA (Time Division Multiple Access)
11
Media Acces Control (MAC)
Supports many different physical layer specifications, both licensed and unlicensed.
Connection orienteded Connection ID (CID)
Channel access: UL-MAP
Defines uplink channel access Defines uplink data burst profiles
DL-MAP Defines downlink data burst profiles
UL-MAP and DL-MAP are both transmitted in the beginning of each downlink subframe (FDD and TDD).
12
FDD Downlink subframe
Source: D. Miorandi Create Net
13
Uplink subframe
Source: D. Miorandi Create NetGrant bandwidth to specific SSsSSs transmit in assigned allocation using burst profiles UIUC in UL-MAP
14
MAC sublayers
Service Specific Convergence Sublayer ATM CS defined for ATM service Packet CS defined for IPv4, IPv6, Ethernet Classify service data unit SDUs to proper
MAC connection, preserve or enable QoS and enable bandwidth allocation
15
Common Part Sublayer Point to multi point Request bandwidth, associate QoS, transport and routing data SS has universal 48bit MAC address. BS has 48-bit Base Station ID
(not MAC address) Connections identified by 16-bit CID.
used to distinguish between multiple uplink channels associated with the same
downlink channel
many higher-layer sessions may share same CID (with same service parameters)
Used in MAC PDU
16
Common Part Sublayer
SS enter network is assigned 3 management connections Basic connection: transfer short critical MAC messages Primary connection: transfer longer more delay torelent messages
(authentication, connection setup) Secondary connection: transfer of standard base management
messages such as DHCP, TFTP, SNMP In addition, transport connection for contracted services Other additional connections:
Contention based initial access Broadcast transmissions for Downlink, polling of SSs if needed Additional connections for multicast
17
MAC PDU format MAC PDU Formats
-The MAC PDU (protocol data unit) is the data unit exchanged between the MAC layers of the BS and its SSs.
-Consists of a fixed-length MAC header, a variable-length payload, and an optional cyclic redundancy check (CRC).
MAC Header Formats
Two MAC header formats: The first is the generic MAC header that begins each MAC PDU containing either MAC management messages or CS data. The second is the bandwidth request header used to request additional bandwidth.
18
MAC PDU header
19
Transmission of MAC PDUs Transmission Convergence sublayer is between MAC and PHY Transformation of variable length MAC PDUs into fixed length FEC block
MAC Message SDU 1 SDU2
PDU1 PDU2 PDU3 PDU4 PDU5MAC PDUs
P FEC1 FEC2 FEC3Burst
Preamble FEC blocks
20
MAC Management Messages (rules)
Handle initial ranging, negotiation, SS authentication and registration, and describing downlink and uplink link describing:
BS transmits channel uplink and downlink descriptor messages (UCD and DCD) at periodic intervals
UCD and DCD contain burst profile: info on modulation, error-correction, preamble length, etc.
uplink and downlink map messages (UL-MAP, DL-MAP) define burst start times and allocate access to corresponding link channel
ranging: subscriber stations transmit ranging requests at initialization and then periodically
determines power and burst profile changes (starts with lowest power level and then moves up)
Create - net
21
MAC Management Messages
Uplink schedule service Unsolicited Grant Service (UGS) Real-Time Polling Service (rtPS) Non-Real-Time Polling Service (nrtPS) Best Effort Service
Bandwidth request and grants SS authentication and registration
22
Bandwidth request and allocation
SSs may request bw in 3 ways: Use the ”contention request opportunities” interval upon
being polled by the BS (multicast or broadcast poll). Send a standalone MAC message called ”BW request” in an
allready granted slot. Piggyback a BW request message on a data packet.
BS grants/allocates bandwidth in one of two modes: Grant Per Subscriber Station (GPSS) Grant Per Connection (GPC)
Decision based on requested bw and QoS requirements vs available resources.
Grants are realized through the UL-MAP.Source: D. Miorandi Create Net
23
Approaches to Bandwidth Grant Two basic approaches on the way to grant BW Bandwidth Grant per Subscriber Station (GPSS)
Base station grants bandwidth to the subscriber station Subscriber station may re-distribute bandwidth among its connections,
maintaining QoS and service-level connections agreements Suitable for many connections per terminal; off-loading base station’s
work Allows more sophisticated reaction to QoS needs Low overhead but requires intelligent subscriber station
Bandwidth Grant per Connection (GPC) Base station grants bandwidth to a connection Mostly suitable for few users per subscriber station Higher overhead, but allows simpler subscriber
24
Bandwidth allocate by Unicast Polling
1. BS allocates space for the SS in the uplink subframe.
2. SS uses the allocated space to send a bw request.
3. BS allocates the requested space for the SS (if available).
4. SS uses allocated space to send data.
Poll(UL-MAP)
RequestAlloc(UL-MAP)
Data
BS SS
Source: D. Miorandi Create Net
25
Initial Ranging
Upon learning what parameters to use for its Initial ranging, SS scanning for UL_MAP messages present in every frame
SS will send the burst using minimum power setting and try again if it does not get response
BS command timing advance and power adjustment to SS based on SS request. Also provide SS with basic and primary management CIDs
SS receive response: If the response indicates corrections, the SS makes these corrections
and sends another ranging request.
If the response indicates success, the SS is ready to send data on the UL.
26
Negotiation Capabilities and Authentication
Negotiation Capabilities After successful completion of initial ranging, the SS sends a
capability request message to the BS describing its capabilities in terms of the supported modulation levels, coding schemes and rates, and duplexing methods.
The BS accepts or denies the SS, based on its capabilities. Authentication
After negotiation, the BS authenticates the SS and provides key material to enable the ciphering of data.
The SS sends the X.509 digital certificate and certificate of manufacturer and a description of the supported cryptographic algorithms to its BS.
The BS validates the identity of the SS, determines the cipher algorithm and protocol that should be used, and sends an Authentication Reply contain Authorization Key encrypted with SS’s public key.
27
Registration and IP connectivity
Registration SS will register the network after successful completion of authentication It sends a registration request message to the BS, and the BS sends a
registration response to the SS. The registration exchange includes
IP version support SS managed or non-managed support ARQ parameters support Classification option support CRC support Flow Control
IP connectivity After registration SS attains an IP address via DHCP and establishes time of
day via Internet Time Protocol
28
References
IEEE Standard 802.16: A technique overview of the WirelessMANTM Air Interface for Broachband Wireless Access, Carl Eklund, Roger B. Marks, Kenneth L. Stanwood and Stanley Wang, June 2002.
IEEE std 802.16 standard 2004 part 16 (895 pages)
29
Questions ?