ZXG10-BSS Version Upgrade Manual
BTSV6.20.10
ZTE CORPORATION2011
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
TABLE OF CONTENTS
1 BTSV6.20 Version Upgrade Description.........................................................11.1 BTS Version Upgrade Summarized Procedures.................................................11.2 Remarks..............................................................................................................11.3 Notices.................................................................................................................1
2 Upgrade Preparations.......................................................................................22.1 BTS Upgrade Preparation Work List...................................................................2
3 BTSV6.20 (under iBSC) Version Upgrade Steps.........................................3-13.1 Version Upgrade Procedures for a Single Site................................................3-13.2 Version Upgrade of Batch Sites.......................................................................3-83.3 Special Version Upgrade Flow.......................................................................3-12
4 Version Rollback............................................................................................4-12
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. I
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
1 BTSV6.20 Version Upgrade Description
1.1 BTS Version Upgrade Summarized Procedures
Alarm
Before the upgrading, check whether the preparation has been completed according to ZXG10-BSS Version Upgrading
Always record the BS status before the upgrading
Step 1: Choose one site from the physical view to perform BTS single site version upgrade.
Step 2: Perform the batch sites upgrade when the single site version is upgraded successfully.
Step 3: When the upgrade succeeds, delete the version of the site upgraded on the basis of the physical view, so as to keep the version consistency on the whole network.
See notice for the BTS version upgrade in special cases
1.2 Remarks
This manual is applicable to BTSV6.20.102E/BTSV6.20.200E and later versions.
1.3 Notices
BTSV6.20.10 and later versions support enhanced CMB and TRXs. Therefore, please pay attention to the following items.
During the upgrade, it is necessary to upload and configure CML and CLL versions. Otherwise, the BTS cannot be started.
During version rollback, the CML and CLL versions cannot be deleted. Instead, they should be kept there as special versions. Otherwise, the BTS cannot be powered up. And these two versions can be deleted after the rollback succeeds.
IBSCV6.10.003L/IOMCRV6.10.102E supports the download of BTSV6.20.10 and later versions. But the CML\CLL versions cannot be queried.
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 1
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
OMCRV2.97.020B supports the upload and installation of BTSV6.20.10 and later versions. For versions lower than OMCRV2.97.020B, do not use BTSV6.20.10 and later versions.
2 Upgrade Preparations
2.1 BTS Upgrade Preparation Work ListSN Item Record Remarks
1 Current version number 8018
2Backup of foreground ZDB files □Complete □Incomplete
3 Later version software □Yes □No
4 LMT software on Client □Yes □No
5 Local LMT download cable □Yes □No
6 Definition of BTS Software□Through general software□Independent□Both
7BTS Alarm in alarm management □Yes □No
8Channel status in dynamic management □Normal □Exceptional
9Channel occupation in dynamic management □Normal □Exceptional
10Site running status in performance statistic report □Normal □Exceptional
11Record of interrupted/not commissioned site □Yes □No
12 Test MS □Yes □No
13 Test GPRS /EDGEMS □Yes □No
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 2
3 BTSV6.20 (under iBSC) Version Upgrade Steps
3.1 Version Upgrade Procedures for a Single Site
1. Copy the Software Version to the Client Directory.
2. Store the Software and send it to the Peripheral Modules.
Choose View > Software Version Management > BTS Software Version Management > Create Version File in Batch to OMC, as shown in Figure 3-1.
Type Software Remarks
801881128202
CMM, CHP, FUC, CLG, FLG, CMl, CLL, EAM
For all types, CLL and CML versions must be uploaded. Otherwise, the BTS will reboot repeatedly. For Type 8112, the EAM version must be uploaded. Otherwise the BTS will reboot repeatedly.
Figure 3-1 Store BTS Software
3. Synchronize software version to NE.
中兴通讯 版权所有 1
Right-click the version file to be synchronized, and then click Add version file to NE to upload the version file to OMP.
Figure 3-2 Adding Version File to NE
4. Open the Site Specific Software tab and see whether the specific version is created. If it is not created, go to Step 6. If it has been created, deactivate the version first.
On the Site Specific Software tab, select all the specific versions, right-click them and choose Cancel activation.
Figure 3-3 Deactivating File Version
5. Delete specific software version from OMC.
中兴通讯 版权所有 2
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
Figure 3-4 Deleting Specific Version
6. Create specific version file
Figure 3-5 Creating Specific Version File
Configure Site ID.
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 3
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
Figure 3-6 Configuring Site ID
Upload CMM, CLG, FUC, FLG, CHP, CLL, and CML versions respectively with the steps above. After finishing the upload, the created specific versions will be displayed on the Site Specific Software tab.
Figure 3-7 Created Specific Version Files
7. Activate the specific software version of the BTS. Then, BTS will start version download automatically.
Select CMM, CLG, FUC, FLG, CHP, CLL, and CML and activate the versions.
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 4
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
Figure 3-8 Activating Specific Versions
Figure 3-9 Confirm Dialog Box
If the activation succeeds, the BTS starts downloading the version file. We can switch to the signaling tracking software to check whether the installation finishes.
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 5
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
Figure 3-10 Result Group
If the operation fails, please check whether link is established between BTS and BSC, and reactivate the version after troubleshooting.
8. Trace the OAM signaling of the site and make sure the software is installed.
9. Observe the Site Running
Observe through the alarm management whether the site has alarms.
Observe through the dynamic data management whether the channel status is normal and whether the site is occupied normally.
Open the Software Version Management tab and check the running version of BTS.
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 6
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
Figure 3-11 Checking the Running Version of BTS
Figure 3-12 Query NE Version Information
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 7
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
Figure 3-13 Appointed Board Running Version Query
10. Complete the version upgrade for a Single Site
The site upgrade is completed when everything returns to normal.
3.2 Version Upgrade of Batch Sites
1. Copy the Software Version to the Client Directory.
2. Store the Software and send it to the Peripheral Modules
Choose View > Software Version Management > BTS Software Version Management > Create Version File in Batch to OMC.
Type Software Remarks
BTS8000 series
CMM, CHP, FUC, CLG, FLG, CMl, CLL, EAM
For all types, CLL and CML versions must be uploaded. Otherwise, the BTS will reboot repeatedly. For Type 8112, the EAM version must be uploaded. Otherwise the BTS will reboot repeatedly.
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 8
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
Figure 3-14 Store BTS Software
3. Synchronize software version to NE.
Right-click the version file to be synchronized, and then click Add version file to NE to upload the version file to OMP.
Figure 3-15 Adding Version File to NE
4. Update Site General Software.
On the Site General Software tab, select site types to be updated, right-click them and choose Update.
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 9
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
Figure 3-16 Updating General Software
Select the software version to be upgraded in the uploaded software list.
Figure 3-17 Selecting Software Versions
Update other software versions with the same steps. Then, BTS will start version download automatically. CMM, CHP, FUC, CLG, FLG, CMl, CLL
5. Trace the OAM signaling of the site and make sure the software is installed.
6. Observe the Site Running
Observe through the alarm management whether the site has alarms.
Observe through the dynamic data management whether the channel status is normal and whether the site is occupied normally.
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 10
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
Open the Software Version Management tab and check the running version of BTS.
Figure 3-18 Checking the Running Version of BTS
Figure 3-19 Query NE Version Information
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 11
ZXG10-BSS Version Upgrade Manual Internal Use Only▲
Figure 3-20 Appointed Board Running Version Query
Perform dialup test on the various cells of the key sties.
Observe the performance indexes of the whole network within two days after the upgrade, and handle the poorest cell (if any) as soon as possible
7. The site upgrade is completed when everything returns to normal.
The site upgrade is completed when everything returns to normal.
3.3 Special Version Upgrade Flow
NULL.
4 Version RollbackIf the BTS does not work properly after the version upgrade, and it is necessary to roll back the version, please reinstall the old version according to the upgrade flow.
Note:
During version rollback, the CML and CLL versions cannot be deleted. Instead, they should be kept there as special versions. Otherwise, the BTS cannot be powered up. And these two versions can be deleted after the rollback succeeds.
ZTE Confidential Proprietary © 2023 ZTE CORPORATION. All rights reserved. 12