X 3700 175 165 T Specifications Sheet

8/14/2019 X 3700 175 165 T Specifications Sheet

1/16

X-SERIESX-SERIESS RI Ssolar outdoor lighting systemsolar outdoor lighting systemSolar Lighting International is the leading manufacture

of the worlds brightest solar light, the X-Series.

SLIs WhiteLighttechnology sets new standards for

illumination, security and night-time visibility.


2/16

X-3700-175-165-T HID MPPT Solar Lighting System

SOLAR ARRAY

Qty. 1- Top of Pole Solar mounting rack series 5000 SeriesQty. 1- 165/170/175/180/185 watt solar module (Sharp or equal)

Qty. 1 MC quick connector set to wire array to power center

POWER CENTER

Qty. 1- Aluminum enclosure, pre-wired with keyed lock on front panel

(All enclosures will have the same keyed lock)

Qty. 2- Knockouts with 2 liquid tight strain reliefs includedQty.1- Solar Lighting International Maximum Power Point Tracking (MPPT) charge

controller

Qty. 2- 30A breaker for safetyQty. 1-Gel battery pack

Qty. 2- 2-24 inch galvanized threaded rod with 4 washers and 4 nuts to mount power

pack to pole

LUMINAIRE TESTED AT FACTORY PRIOR TO SHIPMENT

Qty. 1- GE MR2C Full cut off Dark Sky compliant cobrahead

Qty. 1- SLI X-Series Ballast and igniter assemblyQty. 1- X-HID 3700 Lumen Metal Halide type light Capsule/ Bulb

Qty. 15 Feet of sunlight resistant 10/2 wire

Pole and arm sold separately.


3/16

Series 5000 Single Row Pole Topwith SolarMountRails

Installation Manual 501.5

Un

irac

Insta

llation

ManualSeries

Unirac welcomes input concerning the accuracy and user-friendliness of this publication. Please write to [email protected].

Pub 090616June 200

2009 by UniraAll rights reser

See www.unirac.comfor your nearest Unirac distributor.

Unirac

In

stallation

Manual

U.S. Des. Patent No. D496,248S. Other patents pending.

Stainless steel hardware can seize up,a process called galling. To significantly

reduce its likelihood, (1) apply lubricantto bolts, preferably an anti-seize lubricant, avail-

able at auto parts stores, (2) shade hardware

prior to installation, and (3) avoid spinning onnuts at high speed. See Installation Supplement

910, Galling and Its Prevention,at www.Unirac.com.

Parts List (Parts are illustrated in exploded views, pp. 24.)

Wrench

Part Qty size

Channel 1Bracket, left 1

Bracket, right 1SolarMount standard rail, drilled 2

U-bolt, 38 2Hex head bolt, 38 8 916

Flange nut, 38 4 916

Self tapping screw, no.10 zinc 2

Module clip 4*

Module bolt, 4* 716Flat washer, 4*

Flange nut, 4* 716

The installer is solely responsible for:

complying with all applicable building codes, in-cluding any that supercede these instructions;

pole installation appropriate to local wind and soil

conditions;

using only Unirac parts and installer-supplied parts

as specified by Unirac (substitution of parts will

void the warranty); installing all electrical aspects of the PV array.

Thank you for purchasing a Unirac. Please read these

guidelines completely before proceeding.

This rack is intended for a 2.5-inch (65 mm) Schedule 40

steel pole, outside diameter 2.875 inches (73.0 mm). Forlarger diameter poles, Unirac can fill special orders for

larger U-bolts.

* Per module to be mounted. Series 5000 racks include module hardware tomount 1 or 2 modules, depending on the model number.


4/16

Page

3

Installation Manual 501.5 Series 5000

AssemblyAssembly order is not criticalexcept for installation of the self-tapping

screws, which occurs last. You may work either from the pole outward, or youmay complete the rack/PV module assembly before mounting it to the pole.

Loosely assemble all components.

Be certain that the channel is centered on the pole and that brackets sit with thepivot hole above the arc hole.

Pre-drilled hole

SolarMountrail

Self tappingscrew

Bracket

Pre-drilled hole

Channel

Pivot hole

Arc hole


5/16

The SunWize 170/175/180 module falls into the mid-range of price and efficiency and

is aimed at residential and commercial grid-tie applications. It is made of high efficiency

mono-crystalline silicon solar cells. Every cell is tested and electronically matched to

maximize output. The modules are manufactured according to the strict requirements of

international and US quality standards. 25-year limited warranty.

Features include:

Cells are laminated between sheets of ethyl vinyl acetate (EVA) for moisture free

protection, UV stability and electrical isolation

Tempered, high-transmittance glass is used for strength and high power output

The module is framed with a strong, corrosion-resistant clear anodized aluminum with

multiple mounting holes for ease of installation

Modules are equipped with multi-string by-pass diodes so that the modules will function

even if partially shaded

Highly resistant to hail, moisture, wind speed and other environmental factors

Junction box is equipped with + and MC 3mm (36 male/female) cables

Wide operating range: from -45C to 95C with 100% relative humidity

US listed to UL-1703, cUL and IEC international standards

SunWize

SW170/175/180 Solar ModuleHigh performance for commercial and residential applications

RELIABLE PEOPLE ::: RELIABLE PRODUCTS ::: RELIABLE POWER

Model Rated Power Rated Voltage Rated Current Open Circuit Short Circuit

(Watts) (Vmp) (Imp) Voltage (Voc) Current (Isc)

SW170 170 36.25V 4.69A 43.9V 5.15A

SW175 175 36.50V 4.80A 43.9V 5.20A

SW180 180 36.60V 4.92A 44.0V 5.30A

Standard Test Conditions: 1000 W/m2, 25C, AM 1.5


6/16

SW170/175/180 Solar Module

SW170/175/180

Dimension inches mm

A 62.20 1580

B 31.81 808

C1 1.65 42

C2 0.53 13

D 31.49 800

E 30.15 766

F .27 7

G 1.25 32

Weight 37.5 lbs. 17 kg.(approx.)

WarrantyThe SunWize SW170 /175/180 module carries a

25-year limited warranty on power output.

CerticationsAll SW modules are UL-1703 and cUL listed and

ISPRA certied to international standards.

Electrical Performance

Voltage (V)

Current(A)

Electrical / Thermal Parameters

Cell Type Moncrystalline Silicon

Circuit Interconnection 72 125 x 125 mm cells, connected in series

Max System Voltage 600Vdc

Series Fuse Rating 12 Amps

NOCT 49C

Voltage Temperature coefficient (Voc) -0.34%/C

Current Temperature coefficient (Isc) 0.09%/C

Power Temperature coefficient (Pmax) -0.37%/C


7/16


8/16


9/16


10/16


11/16


12/16


13/16R-8/2001

M-250ROADWAYLIGHTING

GE Lighting Systems, Inc.www.gelightingsystems.com

Registered Trademark of General Electric C

Trademark of General Electric CompanyData subject to change without notice

ORDERING NUMBER LOGIC

PRODUCTIDENTXXXX

LIGHTSOURCEX

VOLTAGE

X

BALLASTTYPEX

IES DISTRIBUTIONTYPEXXX

LENS TYPE (PRISMATIC)REFRACTORX

OPTIONS

XXX

M2RC =M-250R2 withCutoff Optics

S = HPSC = MercStandard:Lamp notincluded.

60Hz0 = 120/208/

240/277Multivolt

1 = 1202 = 2083 = 2404 = 2775 = 4807 = 120X2408 = 240V

Ballast 120V PEReceptacle notreconnectable

D = 3 47F = 120X347T = 220

W = 230

50Hz6 = 220R = 230Y = 240

NOTE: Dualvoltage connectedfor lower voltage

See Ballast Selection TableA = AutoregC = Merc-RegG = Mag-Reg with

Grounded Socket ShellH = HPF Reactor or LagM= Mag-RegN = NPF Reactor or LagP = CWI with Grounded

Socket Shell

See PhotometricSelection Table

S = ShortM = Medium

C = Cutoff

2 = Type II3 = Type III

See PhotometricSelection TableA = Acrylic Clear

GlobeG = GlassL = Polycarbonate

Clear Globe

NOTE:150 watt Maximumwith Acrylic orPolycarbonateRefractors.

C = Charcoal filterF = Fusing (Not

available withmultivolt or dualvoltage)

J = Line SurgeProtector,Expulsion Type

WATTAGE

XX

05 = 5007 = 7010 =10015 =150

(55V)17 =17520 =20021 =100/150

(55V)25 =250

NOTE: Dualwattageconnected

for lowerwattage

2

PE FUNCTION

X

1 = None2 = PE Receptacle

NOTE:Receptacle connectedsame voltage as unitexcept as noted. OrderPE Control separately.

M-250R2 LUMINAIRE

WITH CUTOFF OPTICSAPPLICATIONS For residential streets, access roads, parking lots and other outdoor areas

Universal two-bolt slipfitter Die-cast aluminum housing withelectrocoat gray paint finish

Adjustable mogul base socket(street side) E39 standard

ALGLAS finish on reflector No-tool PE receptacle Plug-in ignitor True 90 cutoffno light

above 90 (meets RP8-2000 forfull cutoff)

External stainless steel baillatch CSA Certified unit available,

contact factory Standard construction is IP55 Plastic Pest guard standard (not

required for 2 in. pipe)

SPECIFICATION FEATURES

All light sources are clear unless otherwise indicated.PHOTOMETRIC SELECTION TABLE

Light LensWattage Source Type MC2* MC3* SC2*50,70,100,150 (55 V) HPS Aor L N/A 9168 (1A) N/A50,70,100,150 (55 V) HPS G 7293(2CL) 7292(1CL) N/A200, 250 HPS G 7306 (2DH) 7305 (1DH) N/A100, 175, 250 Merc G N/A N/A 7300(1B)NOTE: N/A=Not Available

*Meets RP8-2000 for full cutoff

IES Distribution TypePhotometric Curve Number 35-17 ----(Soc Pos)

M2RC 15 S 1 N 2 G MC3 F


14/162001/R-9GE Lighting Systems, Inc.

www.gelightingsystems.com

Registered Trademark of General Electric Company

Trademark of General Electric CompanyData subject to change without notice

REFERENCESSee Page R-38 for start of Accessories.See Page R-42 for Explanation of Options and Other Terms Used.See Pole and Bracket Section Page P-2 for pole selection.

DATAApproximate Net Weight 20-30 lbs 9-14 kgsEffective Projected Area

Flat Glass Unit 0.6 sq. ft. max 0.06 sq. M maxClear Acrylic orPolycarbonate Globe Unit 1.0 sq. ft. max 0.09 sq. M max

Suggested Mounting Height 20-40 ft. 6-12 M

M-250R2 LUMINAIRE

WITH CUTOFF OPTICS

FIXTURE DIMENSIONS

Light Multi- 347, 240/120Wattage Source volt 120 208 240 277 480 120X240 120X347 PE R 220 230 220 230 24050 HPS H,N H,N H,N H,N H,N H,N H,N H,N H,N N/A N/A N/A N/A N/A70,100,150 (55V) HPS A,H,N A,G,H,M,N,P A,G,H,M,N A,G,H,M,N,P A,G,H,M,N G,M G,H,M,N,P G*,H,M*,N G,H,M,N H,M,N N/A H,M,N H N/A100/150 (55V) HPS N/A H,N N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A200, 250 HPS A,P A,H,N,P A,H,N,P A,H,N,P A,P A,P A,P A**,P A,H,N H H A,H,N H H

100, 175 Merc C C,N C C,H,N C C C N/A C,H,N N/A N/A N/A N/A N/A

250 Merc C A,C,N C C,H,N C C C N/A C,H,N N/A N/A H N/A H

NOTE: N/A = Not AvailableNOTE:*Not available in 120X347 voltNOTE:**Not available in 200 watt

Ballast Type/Voltage60Hz 50Hz

BALLAST SELECTION TABLE

M2AC SUGGESTED CATALOG ORDERING NUMBERS

Catalog Number Wattage Light Source Voltage Bal last Refractor Photometr ic(60 Hz) Type Type Distribution

M2RC07S1N2GMC3 070 HPS 120 NPF Reactor Glass MC3M2RC10S1N2GMC3 100 HPS 120 NPF Reactor Glass MC3M2RC15S0A2GMC3 150 HPS 120 NPF Reactor Glass MC3

All GE suggested catalog ordering numbers come with PE receptacle. PE control must be orderedseparately. Order and install SCCL-PECTL if no PE is desired.

Multivolt ballasts can be for either 120, 208, 240, or 277 volt incoming power supply.


15/16


16/16

Documents

X 3700 175 165 T Specifications Sheet