• LED p owe r s u p p l y , c o n t r o l l i n g 3 5 0mA , 7 0 0mA , 1 2V & 2 4V LEDs .

• Wo r k s w i t h l e a d i n g a n d t r a i l i n g e d g ed imme r s .

• C a n u s e a c o n v e n t i o n a l p u s h b u t t o n f o r d imm i n g .

PART CODE : DCJOLLY MD

WORKS W ITH ANORMAL D IMMER

JOLLY LEAFLET.indd 1 24/11/2009 13:26:46

• IP20 independent driver, for indoor use.• Multi-power driver supplied with dip-switch for the selection of the output current.• Active Power Factor Corrector.• Regulating driver with phase cut-off dimmer IGBT and TRIAC.• Light regulation 0-100% by means of PUSH function (mains voltage):- a short push to turn on and off;- a longer push to increase or decrease light intensity;- regulation automatically stops at minimum and maximum values;- for another on, regulation or off command, release the push button and give the desired command again.• Maximum length of the cable, from push button to last transformer, must be max 15 m. In case of applications where the cable is longer than 15 m, keep this separate from the110-240 Volt mains cable.• Synchronization cable is separately supplied.• Maximum 10 drivers in series, controlled by one or more push buttons.• ATTENTION: only use normally open push buttons with no incorporated warning light.• Light regulation 0-100% by means of PUSH.• Class II protection against electric shock following direct or indirect contact.• Current regulation ±5% including temperaturevariations.• Supplied with terminal cover and clamping screws.• Clamping screws on primary and secondarycircuits for cables with diameter:min. 3 mm - max. 8 mm.• The driver can be secured by means of threaded slots.• Protections:- against overheating and short circuits;- against mains voltage spikes;- against overloads.• Possibility of ignition and power off on the secondary for current LED (power LED).• Suitable for the supply of power LED and LED modules.

12

34

56

ON

EC

E

DC JOLLY MD

N

L

+-

PUSH TO MAKE BUTTON

230V

DIP-SWITCH TO SELECTLED OUTPUT

165mm

NORMAL DIMMING

230V

N

L

47m

m

HEIGHT - 35mm

THE DC JOLLY MD DIMMABLE LED DRIVER

Part Code : DCJOLLY MD

JOLLY LEAFLET.indd 2 24/11/2009 13:26:47