WEEK 10

10 .0: Object Snaps Suppose you want to draw a line from the center of the circle to the middle of the vertical line you extended earlier. AutoCAD has a feature that makes this very easy. These are the Object Snaps (or Osnaps "Oh-Snaps"). Type OS <ENTER> . You will see this dialog box appear.

ICON SETTING   ICON SETTING

Endpoint   Perpendicular

Midpoint   Tangent

Center   Nearest

Node  Apparent

Intersection

Quadrant   Parallel

Intersection   None

Extension   Osnap Setting

Insertion Point   Temporary

Tracking Point

    Snap From

You may also see a toolbar with these snaps as shown below.

You may select whichever points you want to 'snap' on an object.

10.1: TEXT command:

Type in TEXT on the command line.Command: textJustify/Style/<Start point>:50,30 Height <5>: Rotation angle <0>:<enter>Text: (Start point 150,75)

10.2: TASK (4)

Draw the figure shown in Fig.( 10.2) below , and add the following :1. All dimensions2. All text

Fig. 10.2