Embed Size (px)
Citation preview
The Shuffle card holder
a minimalist card case with raw Edges - perfect for cork, leather, or vinyl scrapsPDF Sewing Pattern for BeginnersFinished Dimensions: 4” x 2 1/2”
www.iloveyousew.comDesigned by: Cristy Stuhldreher
Love You Sew LLC Copyright 2018 - All Rights Reserved
for the essential cards from your deck
MATERIALS REQUIRED:
• 9 1/2” x 5” cut of Cork/Leather/Vinyl• Marking Instrument• Pattern Template
ADDITIONAL NOTIONS:
• Cutting Mat• Matching Thread• Scissors and/or X-Acto Knife• Ruler• Clips• Teflon or Walking Foot
Main Pocket
Side Pocket
2
Copyright and Licensing Information:You may sell your pouches in small quantities and Love You Sew must be credited for the cardholder design. This pattern is not for mass production. You may NOT redistribute this pattern in anyway and/or claim it as your own.
With public venues limiting the size of purses more and more, I found there is little room left for a full wallet after keys and just a cell phone. I dove into my scrap bin and came up with this minimalist card holder that can hold an ID, a few credit cards, and even some cash.
Use the Shuffle to present gift cards to friends and family, or for yourself! This is a great co-worker and student gift to hold cash within ID lanyards as well.
Important Notes:
Please read all instructions BEFORE starting your project. All pictures are using faux leather, but instructions are all the same with other non-fraying substrates.
1/8” Seam Allowance unless noted.
RS - Right Side of fabricWS - Wrong Side of fabric
Love You Sew LLC Copyright 2018 - All Rights Reserved
Exterior
1. Use pattern templates to cut card holder pieces. Then sub-cut along the pocket line for two separate pocket pieces.
TIP: Use the X-acto Knife and ruler to cut the notch for a clean sharp point.
Instructions:
3. Place the Main Pocket on top of the Exterior WS together with the top and side edges aligned.
2. Place Exterior WS up with straight edge at the top.
4. Place the Side Pocket (RS facing up) on top of the Main Pocket with sides aligned and 1/16” above the bottom edge.
Top1/4” gap
3Love You Sew LLC Copyright 2018 - All Rights Reserved
5. Fold up the notched edge of the Exterior to align with the straight edge at the top. Check that sides are all aligned. Clip into place.
6. Top-stitch along both sides of card holder through all four layers. Back-stitch at the beginning and end of each seam. Trim threads.
Love You Sew LLC Copyright 2018 - All Rights Reserved4
Congrats & Thank you for making a Love You Sew pattern!
Faux Leather featured is “Lucky Penny” from www.sewsweetness.com
Please share your gorgeous new accessory with #shufflecardholder and #loveyousewpatterns on social media. Don’t forget to tag @loveyousew_ on Instagram so I can see those gorgeous makes!
If you have any questions, feel free to email me at [email protected] or visit www.iloveyousew.com.
Check out your handiwork!
Love You Sew LLC Copyright 2018 - All Rights Reserved 9
ExteriorC
ut 1
PocketsC
ut 1
subcut here
Side Pocket
Main Pocket
1”Test B
lock
pattern template:
