SP38 Lapping Tape

Performance & Properties Adhesive Hot melt pressure sensitive

Release liner PET film

Width glue part On top 80 mm On bottom 45 mm

Width release liner On top 100 mm On bottom 60 mm

Temperature range -30°C +80°C

Application temperature +1°C +40°C

Water column of join 250cm

Shear strength 170 N

Peel strength 30 N

Storability 1 year

Storage temperature Stable between -40OC and +80OC

DescriptionHot-melt based, pressure sensitive adhesive tapes integrated to Easy-Trim Breather

Membrane products.

• They create air tight and rainproof sealing of over- laps.

• They accelerate installation process and create “TAPE TO TAPE” joins.

• They improve sealing properties of overlaps in comparison to one-tape

overlap sealing.

• Better adhesion of tapes, comparing to one-tape overlap sealing, especially

in temperatures lower than +5°C. It makes installation in low temperatures

quite easy.

• Due to wider width of release liner, the risk of join contamination by dust and

soot is minimized.

Installation• Place underlay to correct position. Start removing both lines altogether from top

and bottom part, check that bottom and top underlay is in correct position and

join overlaps of underlay. Slightly press join to ensure good sealing.

NOTE: This information is given in good faith being

based on the latest knowledge available to Easy-

Trim Roofing & Construction Ltd. Whilst every effort

has been made to ensure that the contents of the

publication are current while going to press,

customers are advised that products, techniques

and codes of practice are under constant review

and liable to change without notice. Responsibility

cannot be accepted for the application of

products, and no claims can be considered, where

the manufacturer’s instructions have not been

followed. The user should not assume; based on

any information provided in this sheet, that the

product is suitable for any abnormal use. All

products are sold subject to our standard

conditions of sale, available on request.

SP38 Tape on membrane sample

TECHNICAL DATASHEET

find us:Tel: +44 (0) 845 034 6008e: enquiries@easy-trim.co.uk w: www.easy-trim.co.ukf: +44 (0) 845 034 6010

Unit 12B Metcalf Drive Altham Industrial Estate | Altham Lancashire | BB5 5TU | England