T775 Series 2000 Stand-Alone Controller

T775 Series 2000 Stand-Alone Controller

New Product Introduction Sales Presentation

February 5, 2007

2

T775 Series 2000

• T775 Series 2000 replaces- T775 Series 1000 models

- H775 Humidity Controllers

• Release date set for second quarter

• 38 existing models replaced by 14 new T775 models

T775 Series 2000

3

Informative Home Display

Sensor Temperature

Relay Status

Modulating Output Status

Digital Input Status

Easy to Use Keypad

4

Home Screens Provide Useful Info

• See sensor, modulating output, and relay configuration information

• See senor, modulating output, and relay status information• Use the left and right arrow buttons to scroll through status

screens for all defined outputs, modulating, and relays

5

Easy-to-Use Graphical Interface

• Menu driven programming• As easy to use as your cell

phone• Program with clear, plain

language prompts

Easy programming saves installation time

6

Time Clock Scheduler Built-In

• For Setback or Disable Output Option

• Save energy during unoccupied times

• Gives you more control over your equipment without needing to purchase an additional time clock

• All T775 models include the scheduler

Energy saving feature

7

Up to 2 Independent Modulating Outputs

• Configure each output individually for- 0-10 Vdc,

- 2-10 Vdc,

- 4-20 mA, or

- Series 90

• Versatility saves time in selecting the right control for the job

One model handles many field requirements

8

NEMA 4x Enclosure Option

• Protected from water and corrosion

• Install in animal confinement areas, washdown areas, swimming pools, and similar locations

• Fours models with NEMA 4x enclosures; all others have NEMA 1- T775B2016

- T775B2024

- T775M2022

- T775M2014

The right control for harsh locations

9

Modulating High or Low Limit Control

• Equipment protection• If you need to protect a coil

from freezing, or your equipment from overheating

• Gives you the ability to adjust your control temperature at sensor A to protect equipment at sensor B

• Three models offer hi/low limit control feature:- T775R2043

- T775M2048

- T775M2030

Consistent control while protecting your equipment

10

Extended Temperature Range

• Setpoint temperature range of -40°F to 248°F

• Gives you the ability to control a wider range of temperatures with a single device

• One device covers it all

11

Configure Integral and Derivative Times

• For applications where pinpoint control is required

• Option is standard on every device

• PI control on modulating outputs is setup by default to behave just like the previous T775 Series 1000, but now you can adjust reaction times and behavior as you like it, giving you more control.

12

Digital Input Option

• Connect an external time clock or any external switch to the digital input

• Allows you to either disable all outputs or trigger them for a programmed setback temperature

• Standard on all models

13

Reset Models with Simplified Setup

• Vastly simplified reset programming

• Simply enter the high and low control temperatures and the corresponding high and low outdoor temperatures

• Reset saves energy - as the outside temp gets colder you can reset the setpoint temperature to save energy

Faster setup & energy savings for customers

14

Reset Set-Up

15

Power Supply

• All T775s can be powered with low or line voltage- 24 Vac

- 120/240 Vac

• No need to add a separate transformer

No guessing which control you’ll need

16

Configure Minimum Off Time

• Protect equipment by setting a minimum off time if needed

• Reduces the need for a separate time delay device to protect equipment

• Set once for all relays• Option available on all

models with relay outputs.

Set once for all relays

17

Sensor Calibration

• Calibrate input sensors +/-10°F- T775U calibrations values are

+/-10% of the user defined input range

• Use to compensate for resistance drops in wire leads

• Use to offset the input temperature for sensor location or for any other reason

Flexible and accurate control

18

Name Each Sensor

• Select from a list of descriptive labels for each sensor

• Label will always include A, B, and C designators for Sensor A, Sensor B, and Sensor C

• Sensor labels displayed on the Home screen

19

Sensor Names Appear on Home Screen

Sensor Names AlwaysDisplayed on the

Home Screen

20

Display Relay Runtime

• Quickly and easily check to see how many hours a stage has been running

• Reset to zero at any time• Available on all models

Runtime Displayed for Each Relay

21

Locking Keypad

• Keep configuration secure from unauthorized changes

• Easy to lock/unlock but not obvious how to unlock unless you know the system

Lock Icon Indicates Keypad is Locked

22

Fewer Models

• 14 Series 2000 T775 models replace 38 Series 1000 T775 models

• Reduce inventory• Eliminate the headache of choosing the right

controller

Reduced inventory keeps the money in your pocket

23

Standard Models

• Use in standard applications• Minimal setup and configuration required• All models ship with one temperature sensor; all except single

relay model can accept two sensor inputs.• Floating output option now available!

ProductNumber Description Replaces Relay

Outputs

Analog Outputs4-20mA, 0-10Vdc,

2-10Vdc, & Series 90

FloatingOutput*

SensorInputs

# Sensors Included

T775A2009 Standard T775A1001/U 1 SPDT – 1 1

T775B2016 Standard-NEMA 4X – 2 SPDT – 1 2 1

T775B2032 Standard T775A1019/UT775B1000/U

2 SPDT – 1 2 1

T775B2024 Standard-NEMA 4X T775C1009/UT775D1008/U

4 SPDT – 2 2 1

T775B2040 Standard T775A1027/UT775A1035/UT775B1018/UT775B1026/UT775B1042/BT775B1042/U

4 SPDT – 2 2 1

* One floating output eliminates the two relay outputs.

24

Modulating Models

• Use in modulating applications, with the option for relay outputs as well.

• Easily define analog output configuration through programming

• All models ship with one temperature sensor


Outputs



Floating

Output*

SensorInputs

# Sensors Included

T775M2006 Modulating – None 2 – 2 1

T775M2022 Modulating-NEMA 4X

– 2 SPDT 2 – 2 1

T775M2048 Modulating T775E1015/UT775E1023/UT775E1056/UT775E1064/UT775E1098/U

2 SPDT 2 – 2 1

T775M2014 Modulating-NEMA 4X

T775G1005/UT775G1013/UT775G1021/UT775G1039/B

4 SPDT 2 – 2 1

T775M2030 Modulating T775E1114/UT775F1022/UT775F1055/UT775F1089/U

4 SPDT 2 – 2 1


25

Reset Models

• Use in applications requiring reset• All models ship with two temperature sensors


Outputs



FloatingOutput*

SensorInputs

# Sensors Included

T775R2035 Reset option T775J1001/UT775J1076/U

2 SPDT – 1 2 2

T775R2043 Reset option T775J1019/UT775J1027/UT775J1035/U

None 2 – 2 2

T775R2027 Reset option T775J1043/UT775J1050/UT775J1068/U

2 SPDT 2 – 2 2

T775R2001 Reset option – 4 SPDT – 2 2 2

T775R2019 Reset option – 4 SPDT 2 – 2 2


26

Boiler with Reset Model

• Handle multi-stage boiler applications with this single controller.

• 1 dedicated pump output• Staging for up to 12 relays• 1 digital output alarm• Pump exercise, pump pre-purge

and post-purge, warm weather shut-down.

• Displayed run time• Ships with three temperature

sensors

ProductNumber

Description ReplacesRelay

Outputs

Analog Outputs4-20mA,

0-10Vdc, 2-10Vdc,

& Series 90

SensorInputs

Available

# Sensors Included

OutputReset

T775P2003 Special Boiler with Reset – 4 SPDT – 3 3 X

T775S2008 Four relay expansion module – add one or two for a total of 8 or 12 relays.

– 4 SPDT – – – –

27

Stage Sequencer with Reset Model

• Four stages or add up to two optional 4-stage expansion relay modules for 8, or 12 stage operation

• Flexible setup allows you to configure these stages any way you like for heating, cooling or divide up the stages as you like for both heating and cooling

• Operating up to 12 stages, these can control multiple low-mass boilers, chillers, and/or electric heat from a single control

• Expandable to 12 relays with the T775s 4-Relay Expansion Module

• Ships with one temperature sensor

ProductNumber


Outputs

Analog Outputs4-20mA,0-10Vdc, 2-10Vdc,

& Series 90

SensorInputs

Available

# Sensors Included

OutputReset

T775L2007 Stage Sequencer with Reset Option

– 4 SPDT – 2 1 X

T775S2008 Four relay expansion module – add one or two for a total of 8 or 12 relays.

– 4 SPDT – – – –

28

Universal Model – for pressure, humidity, etc.

• Easy setup for configuring control of pressure, humidity, temperature, or any medium with a 0-10Vdc or 4-20mA sensor input.

• Select from a variety of pressure, humidity, etc. sensors for the desired application.

• Control humidity with % RH displayed, or control pressure with in. w.c., psi, Pa, or kPa displayed.

• Outputs include 2 modulating and two relay outputs that can each have its own setpoint.

• Ability to reset the output based on outdoor temperature, handy when you need to reduce window condensation when setting humidity levels

• Complete versatility in a single control allows you the freedom to do what the job requires

ProductNumber


Outputs

Analog Outputs4-20mA,0-10Vdc, 2-10Vdc,

& Series 90

SensorInputs Availab

le

# Sensors Included

OutputReset

T775U2006 Universal - Humidity, Pressure, etc.

H775A1006/UH775A1022/UH775A1048/UH775A1063/UH775B1005/UH775C1004/UH775D1003/UH775E1002/U

2 SPDT 2 2 0 X

29

T775 Legacy Product Comparison

Feature/Function T775 Series 1000 T775 Series 2000

Relays 1 to 4 SPDT 1 to 12 SPDT (with T775S)

Relay Contact Rating 9.8A full load at 120Vac Same

Power Supply 24, 120, 240 VAC Same

Modulating Output 1 modulating, up to 3 SPDT relays

2 modulating,up to 4 SPDT relays.

Scheduler No Standard on all models. Provides one setback period per day, configurable for each day of the week.

Temp Sensor PT3000 PT1000 IEC 751

Watertight Temp Sensor With NEMA 4X models Same

NEMA 4X enclosure Optional up to 4 relays Same

Approvals UL UL, CE, C-Tick

Ambient temp range -40 to 140F same

Modulating outputs: 0 - 10 Vdc, 2 - 10 Vdc, 4 – 20 mA, Series 90 Floating

Requires a separate model for each type supported

Models with mod output support all types (except floating option which is offered on the relay output models).

Supports 0 - 10 Vdc output No Yes

Supports floating output No Yes

Temperature Setpoint Range -40 to 220F -40 to 248F

Differential/Throttling range 1 to 35F 1 to 150F

Integral Action Fixed Configurable (settable integral time)

30

T775 Legacy Product Comparison (cont)

Feature/Function T775 Series 1000 T775 Series 2000

Digital Input Disable all outputs Options:1) Disable all inputs2) Alternate setpoints for all outputs

Reset Yes Yes - with simplified configuration

Reset optional All outputs or none. Configurable for each output

Reset Set up DIP switches LCD user interface

Irreversible setpoint high limit to meet some codes

No Optional

Engineering Units Standard Models F or C Same

Engineering Units Universal Model NA F, C, in wc, psi, %, kPa, Pa

Relay Minimum Off Time No Configurable

Power up action 300 second countdown before control enabled

Minimum off activated at powerup (yes/no choice for each relay)

Sensor Calibration No Yes

Output Sequencing Option No Yes – single setpoint drives multiple relays.

High or Low Modulating Limit Control No Yes

Humidity Control H775 up to 4 relays, 2 sensors required for mod out

Universal Model supports relay or modulating RH control, with Temp Reset option

Boiler Special Model No Yes- single setpoint drives multiple relays,Alarm Output, 3 sensor inputs available (supply, return, outside).

31

Johnson Controls–A350

Strengths• Modular design• Easy to install• Simple to use• Low cost , simple single

relay model (a large share of the business)

• Customer loyalty

Challenges• Multiple parts to buy for

each installation• Cost goes up quickly when

modules are added• Expensive when using

multiple relays with an LCD display

• Feature set can’t compare with T775, see next slide

32

Competitive Comparison–Johnson ControlsFeature Honeywell Johnson Controls

Timeclock with setback 7 day, 2 events per day no

Modulating Outputs 0-10 Vdc, 4-20 Vdc, 4-20 mA, Series 90 & Floating

0-10 Vdc and 4-20 mA

Built-in Display Yes No

High/Low Mod Limit Control Yes No

Wide Setpoint Range -40°F to 248°FAll models, with Celsius

too.

Either -30F to 130F or 90F to 250F

Throttling Adjustment Range 1-150°F 2-30°F

Digital input for setback or disable

Yes No

Sensor Calibration Yes No

Adjustable minimum off time Yes No

Integral voltage options Yes No

Nema 4x Models Yes No

Irreversible high setpoint limit Yes No

33

Tekmar–264 and others

Strengths• Wide Range of products• Application knowledge• Excellent Web site• Support consulting

engineers

Challenges• Can be complicated to set up• Fixed segment display

cryptic to decipher without instructions

• High cost products

34

www.honeywell.com

Documents

T775 Series 2000 Stand-Alone Controller