HS-18 RAHD™

Award Winning HyperSpike™ TechnologyCombining Ultra’s unique and proprietary HyperSpike technology with a pan & tilt positioning device from Moog, the HS-18 RAHD™ is the ideal sound reinforcement solution. With a 153 dB of penetrating acoustics, communicating long distances and through high background noise environments provides an effective means of separating innocents from threats.

With an acoustic footprint up to 1500 m+, clear, intelligible commands and authoritative messages are broadcast to intended targets with exceptional STI ratings of 0.96 out of 1.0.

HS-18 RAHD can be operated remotely across an IP network (wired or wireless) allowing operators to detect and respond to potential threats from a safe distance.

To facilitate remote security operations, the HS-18 RAHD’s equipment bay can easily be configured with an optional video camera, thermal imager, and/or laser vision interrupter. A programmable side mounted spot/strobe light offers added deterrence. The addition of IP-enabled sensors gives security personnel additional time and valuable information to evaluate the potential threat.

Applications

• Military Security• Maritime & Port Security

• Perimeter Protection• Law Enforcement

REMOTEACOUSTIC HAILINGDEVICES_

• Oil & Gas Platforms• Airport Bird Avoidance

• Commercial Shipping• Yacht & Cruiseline Security

HS-18 RAHD SPECIFICATIONS_

Form 500-725 1110

HS-18 RAHD™ SPECIFICATIONS_

Jamison Road Plant 20, East Aurora, NY 14052 USA+1.716.687.4313 Email: dferguson@moog.com

www.moog.com

This product is regulated by the U.S. Export Administration Regulations 15 CFR Parts 730-774, ECCN EAR99, export, disclosure or transfer contrary to U.S. law is prohibited.

Ordering Information

Model No. HS-18 RAHD

Included with HS-18 RAHD

Microphone

Control Software

Optional Equipment

Thermal Imager

Programmable Search Light

Laser Vision Interrupter

Optical Daylight Camera

Features and Benefits

Delivers clear, intelligible messages with a range exceeding 1500 meters

153 dB @ 1m penetrating peak acoustic output

Optimized for human voice communication, 245 – 10,000 Hz

Narrow acoustic beam, +/-5°

High frequency alert tone

Exceptional clarity with STI rating of 0.96 out of 1.0

Acoustic Specifications

Sound Pressure Level, max peak 153 dB @ 1m, A-weighted

Usable Range1 1500 m typical

Beam Width, primary +/-5º (10º conical @ 2 kHz)

Frequency Range 245 – 10,000 Hz

Positioning Specifications

Slew Rate Tilt: 45º / sec Pan: 70º / sec

Range of Motion Tilt: ± 90º Pan: ± 215º

System Specifications2

Input Power 100 – 250 Vac / 50-60 Hz

Communication Interface T10/100 Based Ethernet

System Weight 260 lbs (118 kg)

Color White, optional custom color

Dimensions of System 35" W x 40.5" H x 27" D89cm W x 102.8cm H x 68.5cm D

Equipment Bay Dimensions 6" (15.24 cm) Diameter,5.5" (14 cm) Depth

1Ambient environmental conditions dependent2 Designed to meet harsh, maritime environmental conditions

Ultra Electronics USSI4578 East Park 30 Drive, Columbia City, IN 46725-8869 USA

+1.260.248.3666 Email: sales@ultra-ussi.comwww.ultra-hyperspike.com www.ultra-electronics.com

GeminEye™

Modular Imaging System

PAN & TILTS_

The demand for high performance day/night surveillance is pressing for smaller, smarter, less expensive products. At the same time, the environments in which imaging products must function are increasingly hostile. Responding to this demand, Moog QuickSet developed the GeminEye™ modular imaging system. GeminEye embraces high performance in a small package, and it is designed to be configured for different applications.

Based on our new QPT-LT dual side-mount positioner, it can be configured with single or dual camera blocks for day, night or day/night capability. Various wavelength band sensors and illuminator modules are available. Moog QuickSet queried its extensive customer base, formed over thirty years in the security industry, for a “clean sheet” specification of all salient characteristics needed for creation of the GeminEye.

As a system, GeminEye is completely upgradable with image blocks swappable by the user in the field. Let the GeminEye surveillance system be an important part of your complete security solution.

Available Features

• Compact/ light weight• Quick-change camera modules (blocks) with true

plug ‘n play performance• Network controllable or dedicated (UniCom-LT™) controller• Single universal protocol, unaffected by camera changes• Mil-STD-810F, IP67 (Certified), sealed and pressurized

camera housings• Random vibration (M56) resistant,

Salt/Fog MIL-STD-810F, Meth. 509.4• 10-30 VDC operations• Choice of multi-spectral cameras

• Choice of 360º Pan rotation• Mobile or inverted operation• No exposed wiring• Full two-way communication• Mounting kits• Illuminators with Quick-Site™ boresight mechanism

Sensor Integration

• Visible Spectrum Cameras• Thermal Imagers• Illuminators

GEMINEYE CONFIGURATION_

Applications

Force Protection

Perimeter Direction

Emergency Vehicle Situational Awareness

UGV Navigational Aid

Port & Ship Safety and Security

Mobile Surveillance Systems

Remote Surveillance

Municipal and Utility Surveillance

And Numerous Others

GEMINEYE CONFIGURATION OPTIONS_

Specifications

Operating Voltage 10 to 30 VDC with reverse polarity protection.

Total PowerPan & Tilt Axes: 2.5A pk, 1.2A continuous at 24VDCHeater: 4.5A at 24VDCStandby: 0.45A at 24VDC (no heater current)

Pan Range 360° continuous

Pan Speed 0.25˚ – 100˚/sec

Tilt Range ±95˚

Tilt Speed 0.25˚ – 60˚/sec

Limits Fixed tilt hard limit, adjustable soft limits

Motor Type/Drive Stepper motor drive

Connector Mil spec, bottom egress

Weight Approximately 22lbs (10kg) with dual cameras

Microprocessor Control 32 presets and 2 preset tours

Control Protocols QuickSet or Pelco D

Serial Communication RS422/RS485, IP

Repeatability 0.25˚

Materials Housing 6061-T6 Aluminum, stainless steel hardware, permanently sealed radial ball bearings.

FinishWhite powder coat paint over alodined chromate for corrosion resistance standard. Other colors and CARC available upon request

Enclosures IP67, sealed and pressurized camera housings

Operating Temperature Range -40˚ to 122˚F (-40˚ to 50˚C)

Heaters Pan & Tilt: 65W (1), Camera(s): 10W (1-3 each)Thermostatically controlled: 32°F on/35°F off

Position FeedbackResolution and Readout 0.01˚

Optional Features• Side mount “L” brackets for customer payload• CE compliance• Other accessories available

2

Single Camera w/IlluminatorSingle Camera

Dual Camera

Image BlocksThe camera blocks are designed for quick disconnect from the positioner. Customers can reconfigure systems from day to night payloads or install both at the same time. The image blocks contain embedded translation of the camera operating protocol to the universal protocol of the system. Cameras can be swapped without any change to the system commands. Combined with the Unicom® LT controller or with the system GUI interface, all camera functions are available immediately upon installation. Each camera block is fully sealed and pressurized to assure moisture free operation and long lifetime.

IR IlluminatorIR illuminators are available for enhancing camera penetration during nighttime or low light situations. The illuminators have the options of covert and semi-covert wavelengths. The Quick-Site boresight mechanism is available for near/far field visibility adjustments.

Thermal Cameras

3

This product is controlled under the International Traffic in Arms Regulations (ITAR). This product cannot be exported without first complying with all the requirements of the ITAR (22 CFR 120-130), USML Category XII ©, including requirements for obtaining specific export authority from the United States Department of State.

Thermal Imaging Block Specifications

Detector Type Uncooled Microbolometer

Spectral Range 7-14 µ m (LWIR)

FPA Size 320 x 240 or 640 x 480

HFOV 40°/35°/12°/9°/5°

Analog Video Output NTSC or PAL

Frame Rate 30 Hz (NTSC) / 25 Hz (PAL)

Standard Controls Digital Zoom, Video Polarity, Video Format

Sensitivity <65 mK

Zoom Digital (Continuous Zoom Lenses Available)

Focus Remote or Manual Adjustment Athermalized

Visible CamerasSony 980/1000 color CCD series

Features: Rugged industrial grade, 26x (980) or 36x (1000) optical zoom, electronic image inversion, image stabilization (980 only), low lux capability (1000 only) and DSP technology

Hitachi VKS654 color CCD series

Features: Rugged industrial grade, 35x optical zoom, electronic image inversion, image stabilization and DSP technology

Other camera models available

Visible Camera Block Specifications (Typical)

Detector Type 1/4-type Super HAD™ CCD

Spectral Range Visible 460 to NIR

FPA Size 1/4"

HFOV 42° to 1.6°

Analog Video Output NTSC or PAL

Frame Rate 30 Hz (NTSC) / 25 Hz (PAL)

Standard Controls Digital Zoom, Video Polarity, Video Format, Gain

Sensitivity 1.0 to 2.0 l x Typical

Lens 26x/36x Optical, 12x Digital Zoom

3650 Woodhead Drive,Northbrook, IL 60062-1895 USA+1.847.498.0700 Fax: +1.847.498.1258

www.quickset.com

Form 500-625 0310

GEMINEYE_GEMINEYE_

This product is regulated by the U.S. Export Administration Regulations 15 CFR Parts 730-774, ECCN EAR99, export, disclosure or transfer contrary to U.S. law is prohibited.

Key Features – Unicom® LTTabletop ConfigurationProportional Joystick with high speed and precision movement for pan and tilt movements20 character by-line LCD display screen32 Programmable presets and 2 toursRS232/422/485 Serial data interface9-32VDC power input120/220VAC wall transformerMulti-Sensor ControlManual control of zoom, focus and iris commandsAuto control of focus and iris commandsOptional video display insertion module for visual overlay of positionConfigurable with software GUI or LCD menuDimensions: 6.4" L x 9.25" W x 2.25" H (162 x 235 x 57mm) not including joystickWeight: 1.35 lbs (.612 kg)

Unicom™LT ControllerThe Unicom LT controller was specifically designed to interface with the GeminEye surveillance system. The powerful digital controller is capable of managing all camera functions and up to 99 nodes (RS485), yet is very affordable. For additional information, request the UniCom-LT Controller spec sheet.

Key Features – Unicom®

Tabletop ConfigurationProportional Joystick with high speed and precision movement for pan and tilt movements20 character by-line LCD display screen32 Programmable presets and 2 toursRugged metal weather resistant chassisRS232/422/IP Serial data interfaceRJ45 Connector for Ethernet 10/100 Base T interfaceUSB Connector (2), VGA monitor outputTouchscreen Control GUI Hosting10-28VDC power input120/220VAC wall transformerMulti-Sensor ControlControl of zoom, focus and iris commandsFuture camera specific controls programmableConfigurable with software GUI or LCD menuConfigurable with software GUI or LCD menuDimensions: 7.9" L x 11" W x 3"H (200 x 279 x 76mm) not including joystickWeight: 7.1 lbs (3.22 kg)

Unicom™ ControllerThe Unicom controller is designed for applications requiring IP control on an unlimited number of networked nodes including the GeminEye. The powerful digital controller is capable of managing all networked camera and pan and tilt functions. For additional information, request the Unicom Controller spec sheet.