Upload
shahzad-hussain
View
323
Download
53
Embed Size (px)
Citation preview
Left Click on Hyper TerminalNote: Use HiT7060 Cable (DB9) Connect one end with System Controller and other
with Laptop.
Make New connection, Write Connection Name and Click on OK.
Surpass HiT 7060
Select COM1 and Click on OK
Surpass HiT 7060
Select Restore Default and Click on OK.
Surpass HiT 7060
User Name: root, No need of Password only press Enter.
Surpass HiT
7060
Now you can see All IP address of System.
Surpass
HiT
7060
To set IP, open Local Area Connection.
Surpass
HiT
7060
Right Click on Local Area
Connection and Select Properties.
Select Internet Protocol(TCP/IP)
and Select Properties. In
Internet Protocol Properties
Window Set the IP Address and
Subnet Mask and Select OK.
NOTE: Always Add one digit (1) in Management IP Address and Use as Your Computer IP. e.g. : Management IP: 192.168.0.1 then Computer IP will be 192.168.0.2.
Surpass
HiT
7060
Go to Start → Run Then in run window write CMD and Click on OK.
Surpass
HiT
7060
Ping Computer IP. If Lost is ‘’0’’ its mean it is ok.
Surpass HiT 7060
Use Route Add ,command NOTE: route add (Node IP) (Management IP) and press enter.
Surpass HiT 7060
After Adding the Route add ping Node IP.
Surpass HiT 7060
Open TNMS-M Surpass HiT7060.
Surpass HiT 7060
Give Node IP Address and select OK.
Surpass HiT 7060
Give User Name: root and Password: public and select Connect.
Surpass HiT 7060
Chassis View will be display after some time.
Surpass HiT 7060