Upload
others
View
10
Download
0
Embed Size (px)
Citation preview
Step by Step HP Printer Installation Guide for Quantel Medical AXIS II echograph
Copyright © 2011, ENS & Gantec Corporation: The contents of this document are the proprietary information of ENS and Gantec Corporation and may not be copied, distributed or reverse engineered without prior written permission from ENS or Gantec.
Print2USB Print2USB Installation Guide Connect the Centronics printer cable to the rear side of Echo graph AXIS II device. Plug the other end of the cable to the Print2USB box. In the main menu of the AXIS II, press “F1” button to open the setup menu of the device.
Page 2 of 5
© ENS & Gantec Corporation
Print2USB Print2USB Installation Guide In the SETUP screen, “Parallel Output” will be displayed as “Not used” Press twice the “Right Arrow” button on board of the instrument.
Page 3 of 5
© ENS & Gantec Corporation
Print2USB Print2USB Installation Guide In the SETUP screen, “Parallel Output” will be displayed as “HP” and the Print2USB box driver installed successfully. Press “ESC” button on board of the instrument to exit the setup screen.
Page 4 of 5
© ENS & Gantec Corporation
Print2USB Print2USB Installation Guide The medical device is ready to use for the data transfer. You can take the measurement of the eye; if the Print2USB box is connected both the LED’s (GREEN & ORANGE) will glow. Press “PRINT” button on board of the instrument for Electronic reports.
Page 5 of 5
© ENS & Gantec Corporation