SHALOM SECURITY SYSTEM SOLAR POWER FENCING

Shalom Enterprises, Plot no – 412, Mallareddy Nagar, Gajularamaram, Qutubullapur

Mandal, Hyderabad – 500 055, Ph : 040 – 3100 7374 / 7394, email :

info@shalomsystems.net, mktg@shalomsystems.net,

Web : www.shalomsystems.net

Mumbai Branch:

Mr. Mark Vyas

Cont: 09869083170 E mail: mark@shalomsystems.net,

Web: www.shalomsystems.net

We are glad to introduce ourselves as pioneers in manufacturing Solar Power Fence, Carefully

understanding quality expectations from our customers with engineering imaginations we manufacture &

develop the products according to the client requirement.

The Solar fence is scientific fence and works on the solar energy with backup facility to run uninterruptedly

during the nights as well as cloudy days. The Solar photovoltaic module in the solar fencing generating 12

volts which is fed to solar pak magnum hence converting it into 8000 to 10,000volts in pulses.

Solar fencing is not fatal or harmful as these system works only on solar power DC with low amps

current i.e. 300Milli amps.

When an intruder comes into contact with the electric Fence, they receive a sharp, short, painful but safe

electric shock in pulsated form. The shock does not cause any physical damage. The electric fence acts as a

strong psychological barrier as any intruder avoid coming into contact with the electric Fence once they

experience the shock. After a period of conditioning, the mere presence of the fence acts as an effective barrier

even if it is not powered 'ON'.

Electric fence can be made to detect a fault on the fence like shorting or cutting of the wire due to tampering

on the fence with the Alarm system.

Solar Electric Fence system requires very low maintenance.

The major advantages of Electric Fences over traditional fences are : -

Fence posts are erected 3 - 8 mts apart depending upon the terrain.

No barbed wires are used. Only plain High tensile (Strong) wire is used.

A long life as the fence is not subjected to physical pressures of wear and tear.

Selective barriers possible. For example, Elephant barriers can be designed to allow smaller animals

like cattle to move in and or out.

It is the most effective method of fencing, and is safe to all kinds of animals and to human beings.

It is easily constructed and maintained.

It is long lasting and can be modified, extended, shifted and re-erected from one place to another,

without loss of materials and waste of labor.

This is the only method of fencing, which can effectively keep all kinds of

wild animals out.

It is not dependent on regular electricity supply as it operates on battery.

The system will be a Non-Lethal Solar Powered Perimeter Security system

The system will alert any kind of intrusion through an audio alarm System that can be in the

vicinity of more than 300 meters, within a second.

The system will operate as a Psychological and physical Barrier

The security fence system will produce a high voltage at an energy output of 3.5 Joules, which will

act as an active deterrent, a physical barrier and a reliable detection system.

The security fence system produces a high voltage in the range of 7.0 kV to 9.9 kV (No load) to deter,

detect and deny physical intrusion by giving the intruder a short, sharp and painful shock.

The Energizer will be able to check the fence around 50 times a minute and the instant the pulsated

wires are cut or tampered, a built-in-alarm will immediately alert the monitoring personnel and the

security authorities, along with the zone of attempted break in.

External Alarm will be activated within a second. As a precautionary means an internal alarm is

provided as a substitute in case of failure of external alarm.

The Lead Acid Battery (Reputed Make) along with electronic system will be concealed in a Metal box.

A Live light fixed on the fence will indicate the activeness of the solar system.Solar PV Module of

MNRE approved make will be supplied, which can generate the required power to charge the Lead

Acid battery. In general the Battery back up provided will be for 120 Hrs. in the event of complete

darkness or solar power input failure.

SOLAR POWER FENCE COMPONENTS

Solar Photovoltaic Module, Battery, Charge Controller unit, Energizer, Alarm, Fence with

poles, GI wire, Insulators, Wire tightness , earthling kit and neon tester etc.

Technical Specifications of Solar Power Fencing System

The solar power fencing system will have : -

1) Solar Photovoltaic Module

2) Battery

3) Charge Controller unit

4) Energizer

5) Alarm

6) Fence with poles, GI wire, Insulators, Wire tightness , earthling kit and neon tester etc.

The technical details of each and every component are explained below in detail in the

following pages.

1. Solar Photovoltaic Module

The solar panel is an assembly of Solar Photovoltaic Cell, Toughened Glass and Aluminium

frame to hold the assembly. The Solar cells are cut into pieces and soldered together to make

a solar panel. The solar panel output will be measured in terms of “Peak Wattage (Wp)”.

When the sun rays falls on the solar panel it produces electrical power and that power will be

stored in a battery for further use. The solar panel will be fixed permanently on the roof facing

towards sunrays. Generally solar panel will be installed facing towards south direction to

collect more sunrays. The outputs from solar panel will always a DC output.

2. Battery

The electrical energy produced by the solar panel will be stored in a battery. The battery

works like a energy storage device. Generally the output from battery is DC output.

3. Charge Controller Unit

Solar Charge Control Unit will be used to connect solar panel to battery. This unit is used to

control the charging of battery due to variable sun intensities and protecting the battery from

“deep discharging” and “over charging”.

4. Energizer

The output from the battery (12V-DC) will be connected to the Solar energizer (or) Amplifier.

The energizer amplifies the voltage from 12V to maximum of 7500-10000 Volts and this

voltage will be passed to the fence wires. The output from the energizer will be pulsated

current. When an intruder tries to hold/cut the wire it gives severe shock (Person will not die)

and at the same time alarm will be ranged immediately.

The parameters of the energizer are as follows

Input voltage : 12 V DC

Input current : 500 MA

Output voltage : 7.5 KV to 9.9 KV

Output current : 7 to 8.5 A

Pulse interval : 1.2 second

Pulse duration : 0.3 mille second

Output energy : 2.5 Joules

A 12VDC supply with the help of a Red LED will be glowing to indicate the availability of

DC supply to the Fence Voltage Alarm.

5. FENCE

The fence consists of poles (Center or corner), GI wire, Insulators, wire tighteners and Joint

clamps, earthing kit etc.

Poles (or) Posts

The poles are generally fabricated with Ms-Pipes(Galvanized or Powder coated) 25mm square

thickness 2mm , Insulators will be welded permanently to the poles through welding process.

Insulators

High voltage power will be supplied to fence wires. The fence wire will be passed through an

insulator. The insulator abstruct power supply to the pole that holds the insulator & fence

wire. Corner Pole insulator or Strain Insulators will be used for starting, end or corner posts.

These insulators are made up of high quality industrial plastic – Polypropylene rated for

15KV UV Stabilized. Reel Insulators will be used for the center posts. These insulators are

made up of virgin Polypropylene plastic UV stabilized rated for 15KV operation.

Wire Tighter

Wire tighter will be used to tighten the wire when it is sagging. Wire tighter will be fixed

permanently to the wire and whenever the wire starts sagging it will be tightened. Generally

wire tighters are made up of special aluminum alloy (Rust proof) designed for 15 KV UV

stabilized operation.

Joint Clamp

Joint clamps are used to connect the fence lines in parallel (or) in series. All the

interconnections on the fence are made with the help of joint clamps. They are made-up of GI

wire, heavily galvanized (Rustproof) of more than 25 microns for long lasting.

Double Insulated Cable

(DI cable): It is used for interconnecting Energizer, FVA, Earthing system and Fence

wires. The inner core of DI cable is made up of 12G galvanized wire and heavily insulated

for eliminating the losses to surrounding materials and improve the connectivity among the

systems. It can withstand high voltage of about 15KV with breaking strength of 740 Kgs.

Warning signboard

Polyethylene plastic with white background and coloured letters.

Earthling System

SS rod/GI Pipe of 4 feet length approximately.

Fence Alarm

An alarm is designed to alert customers as and when the intrusion / tampering or any

type of mischief is occurred over the fence. A siren is activated when tampering of the

lines occurs. The sound can be heard from a distance of about 500 meters.

Fence wire

Fence wire is made up of 2.5 mm dia high tension GI wire. The wire will be heavily

galvanized with zinc coating of 300 grams / Sq.m. It is manufactured by TATA.

Optional Accessories of Solar Power Fencing Unit

Neon Tester

This measuring instrument is a part of the system supply. It can be used to check the status of

the fence. It consists of following indications:

Excellent, Good, Fair, Poor, Very poor.

MS BOX

A box will be provided to keep fence energizer, battery, alarms circuit. Generally this box will

be fitted permanently to a wall. An opening for the box will be provided to open and close the

box.

Shalom Enterprises, Plot No – 412, Mallareddy Nagar, Gajularamaram, Qutubullapur

Mandal, Hyderabad – 500 055, Ph : 040 – 3100 7374 / 3100 7394, email :

info@shalomsystems.net, mktg@shalomsystems.net,

Web : www.shalomsystems.net

Mumbai Branch:

Mr. Mark Vyas

Cont: 09869083170 E mail: mark@shalomsystems.net,

Web: www.shalomsystems.net