Upload
jose-sousa-oliveira
View
57
Download
1
Embed Size (px)
Citation preview
8. A.C. GENERATOR
8-0
VITALITY 50
8 __________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
A.C. GENERATOR__________________________________________________________________________________
SERVICE INFORMATION........................................................ 8-2
A.C. GENERATOR ................................................................... 8-3
8
8. A.C. GENERATOR
8-1
VITALITY 50
Torque: 3.5_ 4.0kg-m
Torque: 0.8_ 1.2kg-m
Torque: 0.6_ 1.0kg-m
Torque: 0.8_ 1.2kg-m
8. A.C. GENERATOR
8-2
VITALITY 50
SERVICE INFORMATION
GENERAL INSTRUCTIONS
• All A.C. generator maintenance and inspection can be made with the engine installed.• Refer to Section 16 for A.C. generator inspection.
TORQUE VALUE
Flywheel nut : 3.5_ 4.0kg-m
SPECIAL TOOLS
Flywheel puller E001Universal holder E017
8. A.C. GENERATOR
8-3
VITALITY 50
A.C. GENERATORREMOVALRemove the right side cover. (13-4)
Remove the three bolts attaching the fancover to remove the fan cover.
Remove the cooling fan by removing thefour bolts.
Hold the flywheel with an universal holderand then remove the 10mm flywheel nut.
Universal holder E017
Fan Cover
Bolts
Bolt
Nut
Universal Holder
Cooling Fan
Special
8. A.C. GENERATOR
8-4
VITALITY 50
Remove the A.C. generator flywheel usingthe flywheel puller.
Flywheel puller E001
Remove the A.C. generator wire connector.
Remove the two pulser coil bolts and pulsercoil from the right crankcase.Remove the pulser coil wire clamp from theright crankcase.Remove the two bolts attaching the A.C.generator stator.
Be careful not to damage thedisconnected wire.
°Ø
Lock Nut Wrench
A.C. Generator Wire Connector
Stator
Flywheel Puller
Pulser Coil
Wire Clamp
Special
8. A.C. GENERATOR
8-5
VITALITY 50
INSTALLATION
Install the A.C. generator stator and pulsercoil wire clamp onto the right crankcase,and then install the pulser coil.
Connect the A.C. generator wire connector.
Clean the taper hole in the flywheel off anyburrs and dirt.Install the woodruff key in the crankshaftkeyway.
Install the flywheel onto the crankshaftwith the flywheel groove aligned with thecrankshaft woodruff key.Hold the flywheel with the universal holderand install the 10mm flywheel flange nut.Torque: 3.5_ 4.0kg-mStart the engine and check the ignitiontiming. (3-14 or 3-15)
Universal holder E017
A.C. Generator Wire Connector
Woodruff Key
Universal Holder
Special