DragonFire

DragonFire Racing3191 N Washington St. Suite 2Chandler, AZ 852251 (800) 708-9803http://www.DragonFireRacing.com

Slayer Sport Side MirrorsPart # 04-0045 Multiple Vehicles

Congratulations on your purchase of DragonFire Racing Sport Side Mirrors! Now YOU can check on your buddies eating your dust with the stylish side mirrors. Adjustable and off-road ready. Be sure to check out the full line of DragonFire Accessories for

your vehicle at your local authorized dealer or online at http://www.DragonFireRacing.com

DisclaimerOff road activities can be hazardous and could lead to injury, dismemberment, paralysis and death. No warranty of representation is made as to the products ability to protect the user from any injury or death. The user assumes that risk. The acceptance and /or use of this merchandise purchased from DragonFire by the customer hereby shall release DragonFire from any and all liability pertaining to the use of such merchandise.

• Read and understand these instructions before installing product• Installation may scratch powder coat or paint• Improper installation may result in unsatisfactory viewing angle• Do not use product if there are any signs of damage

Tools Required4mm Allen Bit or WrenchRatchet

Pre-installation: Lay out components and compare to list and images. Part & Hardware List

ITEM QTY SIZE LENGTH TYPE STEP USEDP1 1 - - Slayer SS Mirror LH* AllP2 1 - - Slayer SS Mirror RH* AllP3 2 - - Rubber Pad Insert 4P4 2 - - Indicator Disk (Extra)

* Driver and Passenger Mirror will be determined by the logo in the correct orientation.

P1

P2

P3

Note: An assistant may be needed to hold the product in place during installation.

P4

DragonFire

Step 1: Place vehicle on a flat and level surface. Place gear selector in “Park” and remove keys from the ignition.

Step 2: With the 4mm Allen wrench, remove 2 bolts on the side from the mount of the Sport Side Mirror [P1 or P2] (Figure A). Set the bolts and clamp band aside for next step.

Step 3: Place mirror and clamp band onto the frame of the vehicle at the desired location (Figure B). Loosely tighten the 2 bolts removed in Step 2.

Step 4: Place a Rubber Pad Insert [P3] where shown (Figure C).

Step 5: Position the mirror at the desired height. While holding rubber pad in place, tighten middle bolt (shown by arrow) until clamp is secured (Figure D).

Step 6: Rotate mirror to desired position on the frame and then tighten the 2 bolts on the side until secured (Figure E).

Step 7: Loosen the middle bolt just enough to rotate mirror on the clamp. Do Not uninstall bolt completely. Adjust mirror to desired position and then tighten the middle bolt until secured (Figure F).

Step 8: When mirror is at the desired height and viewing angle, check to ensure all bolts are securely tightened (Figure G). Repeat installation instructions for opposite side Sport Side Mirror.

Step 9: This completes installation. Time to ride and enjoy!

ProTip: Periodically check all hardware and re-tighten if needed.

For further assistance please contact us at customerservice@dragonfireracing.com or 1-800-708-9803.