; -------------------------- How to use this file
-------------------------------; ; To run this installer in quiet
mode: ; 1. Edit the information below to match your company
information and install lo cation. ; 2. Run : setup.exe /q
/AcceptLicenses yes. Passing the val ue "yes" ; to the
/AcceptLicenses parameter indicates that you agree with the license
agreements. ; Alternatively, instead of /q, /qb can be used to run
the installer in basic UI mode. ; 3. The installer will
automatically restart your system after the installation is done. ;
To prevent the restart use the command line : setup.exe /r:n /q
/AcceptLicenses yes ; ; Please contact National Instruments support
at www.ni.com/support for further assistance.
; -------------------------- Set user information
-------------------------------; If the SerialNo key exists but its
value is empty, and the installer suppor t an evaluation mode, then
an evaluation mode will be selected by default. [UserInfo] Name=
Company= SerialNo= ; -------------------------- Set feature states
-------------------------------; The valid feature states are
Local, Absent, NoChange and Default.
; Local - Install it (on the local hard drive). If already
installed leave i t installed. ; Absent - Do not install it. If
already installed uninstall it. ; NoChange - Do not install it. If
already installed, leave it installed. ; Default is equivalent to
not listing the feature in this file. The feature follows its
default behavior. [Features] EWBPro.EWB.PRO.120=Default
EWBCosim.EWB.COSIM.120=Default ; -------------------------- Set
Install Directories -------------------------------; ; *** To use
the default paths, remove the following section *** [Directories] ;
This determines where on your hard drive the National Instruments
directory go es.
; Leave this directory commented out if you prefer the default
directory be used . ;=C:\Program Files\National Instruments ; ;
Additionally, for each feature in the installer, you can specify
where that fe ature will be installed. ; ; NI Circuit Design Suite
12.0 ;EWBPro.EWB.PRO.120=C:\Program Files\National
Instruments\Circuit Design Suite 1 2.0\
