Side view of generator

Close up of unused grounding pad - gives provisions for mounting the absorber

Overview

From N looking S From W looking E

View From top

Grounding pad

Main bar

Hole centers spaced 3.25” horizontally, 1.875” vertically (to match holes in generator)Bottom hole centers 1.25” from bottom of plate.

Note, it would be nice to add 4th row of bolts IF we can mount it without interference on the west side of theplate (toward outboard end of generator)

1.25”

1”

15”

35”

12”

Plate thickness: 1”Plate material: steel

Slot used for mounting weight bar to main bar

Weight Bar12”

6”

Weight bar is 1” thick.

These hole sfor bolt to attach weightbar to main bar slot (nut and bolt)

These holes are tappedto mount fine tune blocks to weight barusing 1.75” long bolt

Fine tune blocks (2)

6”

6”

6”

6”

Fine tune blocks are 1” thick.They will be mounted to the tapped holes in the weight barusing a 1.75” bolt through fine tune block slot

Spacer block (If needed)12”

6”

Spacer bar to mount between the main bar and the generator.Holes drilled in same pattern as main barSpacer bar thickness selected to provide approx 1” clearance betweenmain bar and lifting eye on stator. Maybe 1/2” thick.