santa’s workshopHow to by Edge Marquez(@ popp3d)

CUT AROUND OR

CUT CUT SHAPE OUT

WHAT YOU NEED:A pair of scissors or craft knife or any cutting tool that you have. Glue. Any scoring tool.

And to print out the template in cardstock or any paper thicker than normal copier paper(at least 160gsm)

MOUNTAIN FOLD

VALLEY FOLD

cover acover b

santa

elf

baseglue elf

here

glue santa here

a

b

glue a here

glue a here

glue b here

glue b here

1. Cut and score/fold all pieces

2. Glue cover(a&b) each side of the baseof the card(back side of each fold).

align each corner and edges

do the same on the other side

what card looks like when closed

align each corner and edges while glue it down

what it looks like

3. after gluing the covers, open the card again and glue a and b onto the base

4. After gluing a and b to the base. Get the elf and santa pieces and glue them to a and be respectively

what it looks like

align those corners while gluing it

down(make sure no gray area is showing)