Sample Drawing Package

Item Number Qty. Load Each (VA)

Load Total (VA) Multiplyer

Total Load (VA)

1 1 96 96 1.25 1202 1 9,200 9,200 1.25 11,5003 1 1,200 1,200 1.00 1,2004 19 27 513 1.25 6415 1 768 768 1.25 960

Total 13,461V

Total Load: ÷ 208 ÷ 1.73 =Required Feed:

Power Supply: 120/208V Three-Phase (4-Wire + Ground)

Electrical Calculations:

50

Control Circuit7.5 HP Pump

Low Voltage Lights

Load Type

VA Amps13,461 38

vault support equipment

1/3 HP Sump Pump

Sample Fountain Project (4/5/2010) Equipment List – By Roman Fountains

Item # Qty. Component # Description 01 1 RCN-200 Cascade Nozzle, one-piece machined cast bronze construct ion with 2” (F) N.P.T. connection.

*02 1 RWS-200-S Slab Penetrat ion, machined cast bronze, one-piece const ruction, with integral waterstop flange, brass bonding screw and 2” (F) N.P.T. connect ions.

03 16 RVJ-075 Vee Jet Nozzle, one-piece mac hined brass construction, polished brass f inish & 3/4” (M) N.P.T. connect ion

*04 16 RWS-075-L Slab Penetrat ion, constructed of a Schedule 40 red brass pipe body to ASTM-B-16 brass waterstop/concrete key, continuously welded to pipe at midpoint, brass bonding screw & 3/4” (M) N.P.T. connect ions at ends.

05 16 RBB-075-T Throttling Ball Valve, brass construct ion with 3/4” (F) N.P.T. end connect ions

*06 2 RAVS-1200 12” sq. Ant i-Vortex Plate and Sump Assembly, const ructed of heavy duty FRP sump with integral waterstop flange and 3” (slip) side, and 2” bottom (slip) connections (the 2” internal connection shall be provided with a 2” threaded male plug), 3/16” thick solid brass anti-vortex plate with brass spacers and TORX type stainless steel vandal resistant safety fasteners .

*07 1 RFD-300 Cast Bronze Floor-Drain Fitting, with integral waterstop flange, bonding screw, threaded closure plug with recessed head and 3" (F) N.P.T. outlet connect ion.

*08 1 RNB-075-WND Mechanical Wall-Mounted Overf low/Water Level Control System, consisting of a rugged molded f iberglass niche, brass cover plate with brushed finish, vandal resistant stainless steel fasteners (Torx P in-in T-25 wrench included), overf low standpipe with 2” PVC slip connection, ABS float assembly, 3/4” (F) N.P.T. brass C.W.S. c onnection (from backflow preventer protected supply).

09 19 RFL-CG-FS-LED-W

Freestanding, fully adjustable LED submersible light fixture for floor mounting. High output LED diodes, stainless steel and aluminum housing, fixture base and fasteners, tempered glass lens, silicone lens gask et, chromed brass cord entrance fitt ing; 20' of 18 AWG SJOW cable.

10 2 RJB-6-100-C (Special)

Conduit Mounted Submersible Junction Box, cast bronze construction with neoprene gask et, brass fasteners, (1) 1” (F) N.P.T. bottom power conduit connection WITH 1” X 3/4” REDUCER BUSHING, and s ix (6) 1/2” N.P.T. side connections with brass c ord seal f it tings (shipped loose, installed in f ield). Junction box is E.T.L. Listed, has a minimum volume of 40.0 cubic inches and includes internal grounding lug.


Conduit Mounted Submersible Junction Box, cast bronze construction with neoprene gask et, brass fasteners, (1) 1” (F) N.P.T. bottom power conduit connect ion WITH 1” X 3/4” REDUCER BUSHING, and seven (7) 1/2” N.P.T. side connections with brass cord seal fittings (shipped loose, installed in field). Junct ion box is E.T.L. Listed, has a minimum volume of 40.0 cubic inches and includes internal grounding lug.

*12 3 RWS-075-L Slab Penetrat ion Fit ting, constructed of a Schedule 40 red bras s pipe body to ASTM-B-16, brass waterstop/concrete key flange, continuously welded to pipe at midpoint, brass bonding screw and 3/4” (M) N.P.T. connec tions.

13 6 RPC-2114-D Potting Compound, re-enterable elect rical insulat ing, designed for use in RJB-Series junction boxes (required by NEC 680). 21.2 oz. size.

*14 2 RPS-FA-WS Front Access Surface Skimmer W/Waterstop, body of injection molded black cycolac with removable floating weir / basket ass embly, bronze waterstop fitting attachment, natural f inish cast bronze faceplate, stainless steel fasteners and 1-1/2” (F) N.P.T. connection.

*15 2 REF-150-WS Adjustable ‘Eyeball’ Inlet Fitt ing, machined cast brass cons truction with 3/4” orifice brass eyeball, retaining ring, integral waterstop flange, bonding screw and 1-1/2” (F) N.P.T. connect ion.

16 1 RDP-2-750-RBU (Special)

Series II Direct Burial Pump Vault , consisting of a 4’-0” x 4’-6” x 3’-2” deep heavy duty FRP vault with white gel-coat interior and brown gel-coat exterior, furnished with f iberglass reinforced plastic lid with stainless steel piano hinge attachment, lock hardware (LOCK BY INSTALLER), containing a RSPP-750; 7.5 HP self-priming display pump with integral suction strainer; RCCF-075; 75 sq. ft. cart ridge filter unit ; 4” vent connections with 230 CFM @0.200In. SP vent fan, 1/3HP sump pump assembly; U.L. 508 listed cont rol panel in a NEMA 4 enclosure, containing; main disconnect; pump starter with circ uit breaker, contactor & adjustable, solid-state overload, single channel programmable t ime switch, for pump and lights, H.O .A. switches, plus light ing contactor, FIVE 12V POWER SUPPLIES FOR UNDERWATER LIGHTING; G.F.C.I. breaker & HOT STOP HEAT SWITCH. Unit is pre-wired, pre-plumbed (Schedule 80 PVC) and factory tested, prior to shipment. Power requirement: 120/208VAC, 3-phase, 4-wire feeder + GND.

*NOTE: CONCRETE EMBED ITEM, REQUIRED FOR POUR.

FOUNTAIN PERFORMANCE CRITERIA

The sample water feature depicted in this drawing package is a single level outdoor water feature under a false gravel floor. It contains one 2” cascade nozzle near the center of the pool & sixteen 3/4” vee-jet nozzles arranged in a circular pattern around it. The cascade nozzle operates at a maximum spray height of 15’-0” while the vee-jet nozzles operate at a maximum height of 5’-0” at an angle of 45°. Il lumination for the center nozzle is provided by three low-voltage LED freestanding submersible lights, while the surrounding nozzles are each illuminated by one similar light. Most of the mechanical and electrical controls for the fountain would be housed in a nearby RDP-2 Series direct-buried prefabricated fiberglass vault. This vault would inc lude a 7.5 HP display pump, a 75 Sq. Ft. Cartridge fil ter, chemical feeder, wind compensation control panel, variable-frequency drive & a U.L. l isted control panel. Fountain Information Cascade Nozzle Requirement: 67 GPM @ 40 Feet of Head Individual Vee-Jet Nozzle Requirement: 8 GPM @ 23 Feet of Head Total Vee-Jet Requirement: 120 GPM @ 50 Feet of Head Fountain Display requirement 187 GPM at 70 Feet of Head Area of Pool: 314 Square Feet Depth of Pool: 1’-1 1/2" (1.13 feet) Volume of Pool: 353 Cubic Feet (2,644 Gallons) Filtration Requirement: 11 GPM at 50 Feet of Head (4 hour turnover) Filtration Type: 75 Sq. Ft. Cartridge Filter (RCCF-075) Actual Filtration Rate: 30 GPM at 50 Feet of Head (1 hour 28 minute turnover) 7.5 HP Display Pump (RSPP-750) Delivers: 217 GPM at 71 Feet of Head 225 GPM at 70 Feet of Head

CLIENT NOTE PLEASE READ THIS CRITERIA CAREFULLY. IF THIS IS NOT YOUR UNDERSTANDING AND EXPECTATION OF THE AESTHETICS, OPERATION AND PERFORMANCE OF THIS FOUNTAIN FEATURE, PLEASE NOTIFY US IN WRITING IMMEDIATELY, OTHERWISE THIS DESCRIPTION WILL BE THE BASIS FOR THE DESIGN, MANUFACTURE AND SUPPLY OF THIS SYSTEM.


Item # Qty. Component # Description 01 1 RCN-200 2” Cascade Nozzle.

*02 1 RWS-200-S 2” Slab Penetrat ion.

03 16 RVJ-075 3/4” Vee Jet Nozzle.

*04 16 RWS-075-L 3/4” Slab Penetration.

05 16 RBB-075-T 3/4” Throttling Ball Valve.

*06 2 RAVS-1200 12” Sq. Anti-Vortex Plate and Sump Assembly.

*07 1 RFD-300 3" Cast Bronze Floor-Drain Fit ting.

*08 1 RNB-075-WND Mechanical Wall-Mounted Overf low/Water Level Control System.

09 19 RFL-CG-FS-LED-W Freestanding, adjustable LED submersible light f ixture.


Conduit Mounted Submersible Junction Box.



*12 3 RWS-075-L 3/4” Slab Penetration Fitting.

13 4 RPC-2114-D 21.2 oz.Pott ing Compound.

*14 2 RPS-FA-WS 1-1/2” Front Access Skimmer/Waterstop.

*15 2 REF-150-WS 1-1/2” Adjustable ‘Eyeball’ Inlet Fit ting.


Series II Direct Burial Pump Vault. Power requirement: 120/208VAC, 3-phase, 4-wire feeder + GND.

*NOTE: CONCRETE EMBED ITEM, REQUIRED FOR POUR. NOTE: SEE SHEET WFN-2 FOR FULL ITEM DESCRIPTIONS.


Item # Qty. Component # Description 01 1 RCN-200 2” Casc ade Nozzle.

*02 1 RWS-200-S 2” Slab Penetrat ion.

03 16 RVJ -075 3/4” Vee Jet Nozzle.


05 16 RBB-075-T 3/4” Throt tling Ball Valve.


*07 1 RFD-300 3" Cast Bronze Floor-Drain Fit ting.

*08 1 RNB-075-WND Mechanical Wall-Mounted Overf low/Water Level Control System.

09 19 RFL-CG-FS-LED-W Freestanding, adjustable LED submersible light f ixture.


Conduit Mounted Submersible Junct ion Box.


Conduit Mounted Submersible Junct ion Box.


13 4 RPC-2114-D 21.2 oz.Pott ing Compound.


*15 2 REF-150-WS 1-1/2” Adjustable ‘Eyeball’ Inlet Fit ting.






*02 1 RWS-200-S 2” Slab Penetration.





*07 1 RFD-300 3" Cast Bronze Floor-Drain Fitting.

*08 1 RNB-075-WND Mechanical Wall-Mounted Overflow/Water Level Control System.

09 19 RFL-CG-FS-LED-W Freestanding, adjustable LED submersible light fixture.






13 4 RPC-2114-D 21.2 oz.Potting Compound.


*15 2 REF-150-WS 1-1/2” Adjustable ‘Eyeball’ Inlet Fitting.






*02 1 RWS-200-S 2” Slab Penetration.





*07 1 RFD-300 3" Cast Bronze Floor-Drain Fitting.

*08 1 RNB-075-WND Mechanical Wall-Mounted Overflow/Water Level Control System.

09 19 RFL-CG-FS-LED-W Freestanding, adjustable LED submersible light fixture.






13 4 RPC-2114-D 21.2 oz.Potting Compound.


*15 2 REF-150-WS 1-1/2” Adjustable ‘Eyeball’ Inlet Fitting.




Item Number Qty. Load Each (VA)

Load Total (VA) Multiplyer

Total Load (VA)

1 1 96 96 1.25 1202 1 9,200 9,200 1.25 11,5003 1 1,200 1,200 1.00 1,2004 19 27 513 1.25 6415 1 768 768 1.25 960

Total 13,461V

Total Load: ÷ 208 ÷ 1.73 =Required Feed:

Power Supply: 120/208V Three-Phase (4-Wire + Ground)

Electrical Calculations:

50

Control Circuit7.5 HP Pump

Low Voltage Lights

Load Type

VA Amps13,461 38

vault support equipment

1/3 HP Sump Pump

Documents

Sample Drawing Package