LED Flood LightImportant: Read all instructions prior to installation. AFL Series

4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.comRev Date: V0.1 07/02/2019

5yr

Specifications

Safety and Notes

Operating Voltage Range 120–277 VACTotal Power Consumption 15 W 30 W 50 W 70 W 100 WCurrent Draw 0.13 A @120 VAC 0.25 A @120 VAC 0.42 A @120 VAC 0.58 A @120 VAC 0.83 A @120 VACBeam Angle NEMA 5x6 (80°x110°)Operating Temperature -40°–113° F (-40°–45° C)Environmental Rating IP65Dimmable No

Specifications AFL-xK15-110-x AFL-xK30-110-x AFL-xK50-110-x AFL-xK70-110-x AFL-xK100-110-x

• Product should be installed and serviced in accordance with applicable national, state, and local building and electrical codes.

• To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.

• Avoid looking directly into lamp when illuminated.• Ensure all mounts are securely attached and will support the

weight of the fixture. Failure to properly support fixture may result in damage or injury, for which the manufacturer does not assume responsibility. AFL-50K50-110-U

Wiring DiagramLine

Neutral

Ground

BlackL L

N N

GND GND

White

Dim (+)

Dim (-)

Purple+ +

- -

Gray

Green

User Manual

Installation Instructions (U-bracket/Yoke Mount)

black Lwhite Ngreen

water-proof gasket

lamp

wires

cover of junction-box

screw

knuckle mount

DrillWall

hex-key

hex-key

1. Drill holes for mounting and wiring.2. Loosen light head adjustment screws with hex key.3. Securely attach light to wall and connect wiring.4. Rotate light head to desired angle and tighten adjustment screws.

LED Flood LightImportant: Read all instructions prior to installation. AFL Series

4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.comRev Date: V0.1 07/02/2019

5yr

User Manual

Installation Instructions (Knuckle Mount)

Installation Instructions (Slip-fitter)

black Lwhite Ngreen

water-proof gasket

lamp

wires

cover of junction-box

screw

knuckle mount

DrillWall

hex-key

hex-key

black Lwhite Ngreen

water-proof gasket

lamp

wires

cover of junction-box

screw

knuckle mount

DrillWall

hex-key

hex-key

1. Open junction box and run wiring into box.

2. Securely mount light to junction box. Use sealant to create weatherproof seal.

3. Connect wiring.4. Replace junction box cover.5. Rotate light head to

desired angle and tighten adjustment screws.

1. Loosen light head adjustment screw with hex key.2. Connect wiring.3. Securely attach light to pole/post. The maximum

pole/post diameter is 2.375 in.4. Rotate light head to desired angle and tighten

adjustment screw.

Only available on 70 W and 100 W lights.