Embed Size (px)
Citation preview
Wear the appropriateeye protection duringthe installation!
RKP CC5 1002and RKP CC5 SSRocker Panels
Slide the new panel inplace. Depending on tiresize it may be necessary toremove a tire to keep fromdamaging the new panel.
Once the panel is in place usethe existing panel holes as atemplate. Drill the holes largeenough to accommodate a5/16" bolt. Remove theprotective tape.
Locate and removethe four rubber insertscrews. Remove therubber insert.
Tec Tip:Remove the panel duringdrilling to keep fromdamaging the panelsurface.
Caution: Do not drillinto batteries or gastank! Look before youdrill.....
Copyright© 1997-2010. All Rights Reserved.
