8/14/2019 Revive your Parallel Block

http://slidepdf.com/reader/full/revive-your-parallel-block 1/3

 

 Revive your Parallel Block Revive your Parallel Block Revive your Parallel Block Revive your Parallel Block

being always innovative feels, in the need of hour and technology with

increasing competition….To make you stand apart and Visible, important is supply Quality

product.

In the above photo you can see the Parallel Block most commonly found applicable in every

organization’s workshop to set or rest the products. Repeated use of same block on various

machines / jobs gives bi-product residues due to moisture, coolant, Oil solidification, and

foreign particles on the block. This can be clearly observed in above photo – comparing Right

half [unfinished covered with rust] and left half (finished).

Continuous usage of block also gives dents and scratches on the surfaces, which make

parallel block un-parallel – creating undesirable condition to work further with it. Above

photo – clearly shows dent [on left had side] generated with passing time and usage.

have developed the brushes and holders[Water Flow Through (Patent

Applied)] to restore new life to your used parallel block maintaining your accuracy intact

without changing the block or going for new block.

8/14/2019 Revive your Parallel Block

http://slidepdf.com/reader/full/revive-your-parallel-block 2/3

 

Advantage:-•  It removes rust, dust, muck, foreign particles, sharp corners / edges, without changing

any dimensions.

•  In case of scratches and dents, it removes peaks and leaves valley as it is. seen in the

above photo.

•  Presence of peaks in the surface gives your job point contact, after brushing the area

increases, and you have now more surface contacts then before.

•  Restoring of parallel job is an in-house procedure done on your VMC / HMC which

can be done at regular intervals

BEFORE BEFORE BEFORE BEFORE 

AFTER AFTER AFTER AFTER 

RESULT IS VERY CLEAR, DISTINCT AND APPRECIABLE – CHOICE IS YOUR’S

USING OLD BLOCK OR RESTORE AND MAINTAIN QUALITY!!!!

In the above photo you can see Top left as clean and DeBurred,

Top right as rusted and with foreign particles,

Bottom surface you can easily see the eroded metal and generated cavity as erosion due to

etching with contaminations.

8/14/2019 Revive your Parallel Block

http://slidepdf.com/reader/full/revive-your-parallel-block 3/3

 

Recommendation:-

1.  Holder having Shank Dia. 16mm which you can hold in your ERW / Hydro-grip.

One time investment - same will be used in your machine as a DeBurring Brush

Holder, (the cost is less than 40 Euro)

2.  You need one brush for same Dia. 60mm (less than 26 Euro), also available in other

dia. 80mm, 100mm, 125 mm etc. depending on block size.

Note: Holder also available in Shank Dia. 25, 32mm for Side-lock / Hydro-grip, for brush

dia. 100, 125 & 150mm., And 40mm for brush from 165 to 296mm

For any further queries, please feel free to contact……

pm1@imexsu.in  www.de-burring.com 

8-A, Vaibhav Industrial Estate, Baji Pasalkar Marg, Mumbai - 400072, INDIA.Tel. +91-22-2857-0339/67488999