2
BENARTEX, LLC 132 WEST 36TH STREET, 4TH FLOOR NEW YORK, NY 10018 T:212-840-3250 WWW.BENARTEX.COM Quilt Diagram F F F F G G G G D D D D H Center Block H H H 1 1 2 2 3 3 4 4 5 5 6 6 7 7 8 8

Quilt Diagram...THE QUILT TOP TO ENSURE H, D AND F BORDER SIZES, BELOW ARE OUR CUTTING SIZES. FINISHED SIZE: 66” x 82” FINISHING Cut batting and backing 3” larger than top on

  • Upload
    others

  • View
    2

  • Download
    0

Embed Size (px)

Citation preview

Page 1: Quilt Diagram...THE QUILT TOP TO ENSURE H, D AND F BORDER SIZES, BELOW ARE OUR CUTTING SIZES. FINISHED SIZE: 66” x 82” FINISHING Cut batting and backing 3” larger than top on

BENARTEX, LLC • 132 WEST 36TH STREET, 4TH FLOOR • NEW YORK, NY 10018 • T:212-840-3250 • WWW.BENARTEX.COM

Quilt Diagram

F

F

F F

G

G

G

G

D

D

D D

H

Center Block

H

H H

1

1

2

2

3

3

4

4

5

5

6

6

7 78

8

Page 2: Quilt Diagram...THE QUILT TOP TO ENSURE H, D AND F BORDER SIZES, BELOW ARE OUR CUTTING SIZES. FINISHED SIZE: 66” x 82” FINISHING Cut batting and backing 3” larger than top on

SAMPLE SAMPLEKEY/SKU KEY/SKUQTY QTYCUT CUTCUT PIECES VIA WOF CUT PIECES VIA WOF

BLOCK ASSEMBLY PROJECT USES PRECISE 1/4” SEAMS. TEST YOUR SEAM ALLOWANCE BY CUTTING (2) 2-1/2” X 5” RECTANGLES. STITCH THEM TOGETHER ALONG THE 5” LENGTH. AT THE MIDPOINT, MEASURE ACROSS THE UNIT. IT SHOULD BE EXACTLY 4-1/2” WIDE. IF NOT, ADJUST YOUR SEAM ALLOWANCE AND REPEAT.

BENARTEX, LLC • 132 WEST 36TH STREET, 4TH FLOOR • NEW YORK, NY 10018 • T:212-840-3250 • WWW.BENARTEX.COM BENARTEX, LLC • 132 WEST 36TH STREET, 4TH FLOOR • NEW YORK, NY 10018 • T:212-840-3250 • WWW.BENARTEX.COM

A

C

E

G

I

M

O

K

B

D

H

J

L

N

F

Another Moose is Loose Panel9610-99Brown/Multi

Cardinal with Plaid9617-72 Tan

Wood Tweed9618-77 Brown

Wool Check9614-70 Beige

Pine Bough9612-44Green

Pine Bough9612-12 Black

Wood Tweed9618-78Mocha

Moosehead with Houndstooth9611-77 Brown

Pine Bough 9612-10Red

Moose Twill Crossing9613-44 Green

Moosehead with Houndstooth 9611-44 Green

Cardinal with Plaid9617-78Mocha

Cardinal with Plaid9617-79Espresso

Moosehead with Houndstooth9611-19 Berry

Wool Check9614-10 Red

Fussy cut (1) 22-1/2” x 38-1/2” panel.

(1) 5-1/2” x WOF strip. Sub- cut (2) 5-1/2 x 5-1/2” squares.

(2) 3” x WOF strips. Sub-cut (8) 3” x 5 ½” strips and (8) 3” squares.

(1) 10-1/2” x WOF strip. Sub- cut (2) 10-1/2” x 16-1/2” strips.(1) 10-1/2” x WOF strip. Sub- cut (2) 10-1/2” x 12-1/2” strips.(6) 3” x WOF strips. Sub-cut (40) 3” x 5-1/2” strips.(3) 3” x WOF strips. Sub-cut (40) 3” x 3” squares.

(1) 5-1/2” x WOF strip. Sub- cut (2) 5-1/2” x 5-1/2” squares.

(1) 5-1/2” x WOF strip. Sub- cut (2) 5-1/2” x 5-1/2” squares.

(3) 3” x WOF strips. Sub-cut (16) 3” x 5 ½” strips and (2) 3” x 3” squares.(1) 3” x WOF strip. Sub-cut (14) 3” squares.

(1) 5-1/2” x WOF strip. Sub- cut (2) 5-1/2” x 5-1/2” squares.

(1) 5-1/2” x WOF strip. Sub- cut (2) 5-1/2 x 5-1/2” squares.

(8) 2-1/2” x WOF strips.*

(3) 4-1/2” x WOF strips.*(2) 4-1/2” x 36-1/2” WOF strips.(8) 2-1/2” x WOF strips, BINDING

(1) 5-1/2” x WOF strip. Sub- cut (2) 5-1/2” x 5-1/2” squares.

(1) 5-1/2” x WOF strip. Sub- cut (2) 5-1/2” x 5-1/2” squares.

(1) 5-1/2” x WOF strip. Sub- cut (2) 5-1/2” x 5-1/2” squares.

(2) 4-1/2” x 38-1/2” WOF strips.(2) 4-1/2” x 30-1/2” WOF strips.(8) 3-1/2” x WOF strips.*(10) 3” x WOF strips. Sub-cut (128) 3” x 3” squares.

* SEW STRIPS VIA SHORT ENDS THEN GO TO BORDER ASSEMBLY WOF/LOF=WIDTH/LENGTH OF FABRIC

1/4 yd

2/3 yd

1-1/3 yds

1/4 yd

1/4 yd

1/4 yd

2-1/4 yds

1 panel

1/4 yd

1/4 yd

1-1/2 yds

1/4 yd

1/4 yd

1/2 yd

1/4 yd

BORDER ASSEMBLY MEASURE WIDTH AND LENGTH OF THE QUILT TOP TO ENSURE H, D AND F BORDER SIZES, BELOW ARE OUR CUTTING SIZES.

FINISHED SIZE: 66” x 82”

FINISHING Cut batting and backing 3” larger than top on all sides. Layer backing, batting and top together and baste or pin. When quilting is completed, trim excess batting and backing. Bind as usual.

Note: If this Benartex pattern is included in a kit, any questions about the kit should be addressed to the vendor from whom you bought it.

8. Sew (1) H 4-1/2” x (44-1/2”) strip to each side of the Center Block. Sew (1) H 4-1/2” x (36-1/2”) strip to the top and to the bottom of the Center Block.

Quilt Assembly9. Sew together (1) Block Five square, (1) Block Six square, (1) Block Seven square, (1) Block Eight square and (1) G 10-1/2” x 12-1/2” strip in that order. Repeat to make a second strip. Sew (1) strip to each side of the Center Block.

10. Sew together (1) Block One square, (1) Block Two square, (1) Block Three square, (1) Block Four square and (1) G 10-1/2” x 16-1/2” strip in that order. Repeat to make a second strip. Sew the strips to the top and to the bottom of the Center Block.

11. Sew (1) D 2-1/2” x (72-1/2”) strip to each side of the Center Block. Sew (1) D 2-1/2” x (60-1/2”) strips to the top and bottom of Center Block.

12. Sew (1) F 3-1/2” x (76-1/2”) strip to each sides of the Center Block. Sew (1) F 3-1/2” x (66-1/2”) strip to the top and bottom of the Center Block to make the quilt top.

F

FCenter Block

F F

A

Trim blockto measure

28 ½” x 44 ½”AFTER adding

borders

Unit 1make 8

EF F

Unit 2make 16

OF F

Unit 3make 40F F

G

Block Onemake 2

E EUnit 1

Unit 1

Unit 1U

nit 1

E E

C

Block Twomake 2

Unit 2

Unit 2U

nit 2

Unit 2

O O

O O

K

Block AssemblyPay attention to the unit orientations when assembling the various components.1. Sew (1) F 4-1/2” x 38-1/2” strip to each side of the A 22-1/2” x 38-1/2” panel. Sew (1) F 4-1/2” x 30-1/2” strip to the top and to the bottom of the A 22-1/2” x 38-1/2” panel. Trim the block to measure 28-1/2” x 44-1/2” to make (1) Center Block.

2. Place (1) F 3” square on the left side of (1) E 3” x 5-1/2” strip, right sides together. Sew across the diagonal of the square from the upper right corner to the lower left corner. Trim away the excess fabric from behind the triangle, leaving a 1/4” seam allowance. Flip open the triangle formed and press.

3. Place another 3” F square on the right side of the E 3” x 5-1/2” strip, right sides together. Sew across the diagonal of the square from the upper left corner to the lower right corner. Trim away the excess fabric from behind the triangle, leaving a 1/4” seam allowance. Flip open the triangle formed and press to make (1) Unit 1 strip.

5. Repeat Steps 2-3 and refer to the figures for fabric identification, placement and seam direction to make (16) Unit 2 strips and (40) Unit 3 strips.

4. Repeat Steps 2-3 to make (8) Unit 1 strips total.

6. Sew (1) E 3” square to each end of (1) Unit 1 strip to the make the top row. Repeat to make the bottom row. Sew (1) Unit 1 strip to each side of (1) C 5-1/2” square to make the middle row. Sew the (3) rows together to make (1) Block One square. Repeat to make a second Block One square.

7. Repeat Step 6 and refer to the figures for fabric identification, placement and orientation to make (2) of each square for Block Two through Block Eight.

Unit 3

Unit 3U

nit 3

Unit 3

G G

G G

L

Block Threemake 2

Unit 3

Unit 3U

nit 3

Unit 3

G G

G G

M

Block Fourmake 2

Block Fivemake 2

Unit 2

Unit 2U

nit 2

Unit 2

O O

O O

N

Unit 3

Unit 3U

nit 3

Unit 3

G G

G G

I

Block Sixmake 2

Unit 3

Unit 3U

nit 3

Unit 3

G G

G G

J

Block Sevenmake 2

Unit 3

Unit 3U

nit 3

Unit 3

G G

G G

B

Block Eightmake 2